Wacom PENPARTNER 2 User Manual page 37

Double-clicking is difficult.
The pen selects everything, will
not stop drawing.
You notice a delay at the
beginning of pen strokes.
You have to press hard with the
pen when clicking or drawing.
The pen tip does not function.
The side switch does not work.
C
ONTENTS
I
NDEX
Be sure you are quickly tapping the tablet twice in the same place on the
tablet's active area.
Using a side switch to double-click is recommended (review the techniques
in clicking). See also customizing the side
Try increasing the D
OUBLE
Try using a lighter T F
IP
Try setting your system to launch programs with a single click
(see clicking).
Open the Pen Tablet control panel. Move the T
In the Pen Tablet control panel, try decreasing the D
(see adjusting double-click).
Open the Pen Tablet control panel. Move the T
Make sure the status LED changes from orange to green when the tip is
pressed to the tablet surface. If it does not, you may have defective
hardware (see testing your
Be sure you press the side switch when the pen tip is within 5 mm
(0.20 inch) of the tablet's active area – do this without pressing down on the
pen tip.
From the Pen Tablet control panel, verify that the side switch in question is
set to the function you are expecting to occur.
Make sure the tablet status LED changes from orange to green when you
press the side switch. If it does not, you may have defective hardware (see
testing your tablet).
switches.
-C D (see
LICK ISTANCE
(see adjusting tip feel).
EEL
tablet).
adjusting double-click).
F slider toward F
IP EEL IRM
-C D
OUBLE LICK ISTANCE
F slider toward S
IP EEL
T
ROUBLESHOOTING
Page 37
.
.
OFT