Firewall Settings; Enable Spi; Dmz - D-Link DGL-4500 - GamerLounge Xtreme N Gaming Router Wireless User Manual

Section  - Configuration
A firewall protects your network from the outside world. The D-Link DGL-4500 offers a firewall type functionality.

Enable SPI:

SPI (Stateful Packet Inspection, also known as dynamic packet
filtering) helps to prevent cyber attacks by tracking more state per
session. It validates that the traffic passing through the session
conforms to the protocol.
NAT Endpoint Select one of the following for TCP and UDP ports:
Filtering: Endpoint.Independent.- Any incoming traffic sent to an open port
will be forwarded to the application that opened the port. The port
will close if idle for 5 minutes.
Address.Restricted - Incoming traffic must match the IP address
of the outgoing connection.
Address.and.Port.Restriction - Incoming traffic must match the
IP address and port of the outgoing connection.
Anti-Spoofing:
Click to enable Anti-Spoofing protection.
Enable DMZ Host: If an application has trouble working from behind the router, you
can expose one computer to the Internet and run the application on
that computer. Note: Placing a computer in the DMZ may expose
that computer to a variety of security risks. Use of this option is only
recommended as a last resort.
IP Address: Specify the IP address of the computer on the LAN that you want
to have unrestricted Internet communication. If this computer obtains it's IP address automatically using DHCP, be sure to
make a static reservation on the Basic > DHCP page so that the IP address of the DMZ machine does not change.
Non-UDP/TCP/ICMP Enable this feature to allow the router' NAT to track application that uses protocols other than UDP, TCP or ICMP.
LAN Sessions:
ALG:
Check the PPTP, IPSec, RTSP, and SIP boxes to allow pass-through.
D-Link DGL-4500 User Manual

Firewall Settings

45