Page 1
Thank you for choosing !DEA Wi-Fi Wireless Modem (hereinafter referred to as the E5). The supported functions and actual appearance are subject to your product purchased. The following pictures are provided for illustration only. For details about your product selection, consult your service provider. This guide briefly describes the functions of the E5.
Getting to Know Your E5 Packing List The package box contains the following items. If any of the items is lost or damaged, contact your local dealer. Quick Start Main unit Battery Data cable Safety Information Some of the optional accessories are not provided in the package, you can contact your local dealer to buy them yourself.
Application Scenarios The Wi-Fi device or computer can be connected to the Internet through the E5. The actual connecting procedure depends on the operating system of the Wi-Fi device or computer. You can perform the connection operations as prompted. Scenario 1: Multi-device access Scenario 2: One-device access via Wi-Fi via USB...
Page 4
Scenario 3: Multi-device access via Wi-Fi and USB at the same time Game machine Smart phone Laptop Digital Camera...
Page 5
Appearance Item Screen microSD card slot USB port Power button Wi-Fi/WPS button Dialing button Strap hole Battery button Wi-Fi: Wireless Fidelity WPS: Wi-Fi Protected Setup ...
Page 6
Screen Item Signal strength Network Wi-Fi enabled Number of devices connected Internet connection New messages Number of new messages Power level Roaming state M: Manual mode A: Auto mode ...
Before You Start Installing the SIM Card and the Battery Install the SIM card at the card slot entrance. Ensure that the SIM card faces the direction as shown in the following figure. Then slide in the SIM card. Installing the microSD card Remove the rubber cap from the microSD card slot.
into the slot. After inserting the microSD card completely, attach the rubber cap. Note: The microSD card is an optional accessory. If the microSD card is not provided in the package, you can buy one yourself. To remove the microSD card, open the rubber cap and press the microSD card ...
Page 9
provided by other manufacturers or vendors is used, the E5 may fail to work and dangers may be caused. At the same time, any national regulations on terminal products or warranty applicable to the E5 may fail to work. The charger is an optional accessory. ...
Accessing the Internet through a Wi-Fi Connection Note: By default, the management parameters are preset on the E5 according to the requirements of the service provider. You can follow the steps below to quickly access the Internet. For the details about how to set the management parameters, see the Help on the Web management page.
Note: Press and hold until the screen is off. When the screen is off, it indicates that the E5 is powered off. 2. Establish a Wi-Fi Connection (Take a ® computer with Windows XP operating system as an example) Make sure that the Wi-Fi function is enabled. Select Start >...
Page 12
Click View available Wireless Networks to display the wireless network list. Select the network whose SSID is the same as that of the E5, and then click Note: If the encryption parameter is already set for the E5, the Wireless Network ...
3. Access the Internet After you establish a Wi-Fi connection successfully, you can access the Internet in either of the following two modes. By default, the mode is Auto. Mode Operations Auto After the E5 is powered on, it can automatically connect to the Internet when data transmission is required.
Page 14
Mode Operations disappears, it indicates that the connection to the Internet is disconnected. Note: You can also launch web management page to connect to or disconnect from the network as prompted. Note: You can launch the web management page to select the mode of accessing the ...
Accessing the Web Management Page Make sure that the connection between the E5 and the Client is proper. Start the Internet browser and enter http://192.168.1.1 in the address bar. Enter the password, and then click Login. Note: The default password is admin. Verifying the PIN Code When the PIN code protection is enabled, you need launch the web management page and then enter the correct PIN code as prompted.
Page 16
Access the web management page. Click SD Card to manage the data stored on the microSD card. You can enjoy the short message (SMS) service on the web management page. Access the web management page. Click SMS to view, create, reply, or send a message.
Daily Use Saving Power mode If no operation is performed on the E5 for a while, the screen is off. If the E5 has not been accessed for 30 minutes by default, the E5 changes to the deep sleep state. When the E5 is in the deep sleep state, you can press any key to activate the Wi-Fi function.
disappears. When disappears, it indicates that the Wi-Fi is disabled. Establishing a WPS Connection If the Wi-Fi Clients connected to the E5 support the WPS function, the E5 can generate a network key without manual input. To establish a WPS connection,do as follows: Power on the E5.
Restoring the Factory Defaults If you forget the changes of some parameter settings, you can restore them to factory defaults and reconfigure the parameters of the E5. Press and hold CONNECT at the same time until the screen is off. Then you restore the factory defaults.
Example: Wi-Fi Connection to Game Machine (PSP) Turn on the PSP WLAN switch. Select Settings > Network Settings. Select Infrastructure Mode to connect your local Wi-Fi access point. Select New Connection to specify a mnemonic connection name (such as MyE5). Select Scan to detect networks in range.
Page 21
Select the SSID same as that of the E5. Then press the > button consecutively to confirm the SSID and input the Wi-Fi key. SSID: The Wi-Fi name of the E5. WEP: The Wi-Fi key of the E5. The default SSID and key label is ...
Example: Wi-Fi Connection to Smart Phone (iPhone) Select Settings > Wi-Fi and turn Wi-Fi on. Automatically detect networks in range, and then display the access point list. Select a network whose name is the same as that of the E5. If necessary, enter a password and tap Join.
Frequently Asked Questions (FAQ) What can I do if the Client connected to the E5 cannot access the Internet? Check and ensure that the Client is connected to the E5 properly. Check the power status to ensure that the E5 is powered on. Check the signal strength to ensure that the area is covered by the network.
Page 24
Check that the network adapter of your Client runs properly. If the problem still persists, please consult you service provider. What can I do if the Client cannot access the WLAN? If there are interferences or shields near the E5, you can adjust the position of the E5.