ATrack Technology Inc. products are not intended to be used as life support or rescue equipment. 1.5. FCC Compliance Statement ATrack Technology Inc. is not liable for any loss or injury caused by using or referencing to any of its products. Any possible means of using or integrating ATrack Technology Inc. products shall be This device complies with Part 15 of the FCC Rules.
1.8. CE Representatives (CE Cert. have been processing) 1.6. IC Compliance Statement The followings are authorized to represent ATrack Technology, in compliant to [EN] CE regulation. RSS-Gen Issue 4 8.4 This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference;...
For Reports generated After powering-up and Before GPS-fixed, their GPS_Time & RTC_Time will be counted from 1970/01/01 & 2021/01/01 accordingly. Please activating AS300 outdoor for good GPS reception and you will not have Power ON event report immediately if GPS is not fixed.
AS300 3.3. SIM Card Installation 3. Installation AS300 supports installation of one NANO SIM card. To install a SIM card, please follow the instruction below to remove the cover and insert the SIM. 3.1. Package Content Open the waterproof cover. Please be careful not to pull too hard when opening the cover Verify that you received the following items in the package: to avoid breaking it.
3.4. Configuration Port and Setting Next, connect the USB (Type C) as shown below. The configuration cable is used to connect to the socket inside the AS300 and PC for configuring parameters and firmware upgrade. When the configuration cable is connecting to your PC/laptop, a "USB Serial Port"...
4. Configuration You may explore great features on the AS300 through AT commands either over the direct serial connection or remote via SMS/GPRS. The command syntax for direct or remote connections is the same. Each command should be following the specified format in the Protocol Document, and the command shall end with carriage-return and line-feed characters.
Connecting AS300 Using HyperTerminal button to close the Properties window. The following example shows how to connect the AS300 through HyperTerminal. You may use other popular terminal emulators such as Putty or Tera Term Pro to establish a console session with the AS300.
Page 12
AS300 Click on the [Settings] tab and click on the [ASCII Setup…] button. Check the following options and click on the [OK] button. ATrack Technology User Manual...
Need help?
Do you have a question about the AS300 and is the answer not in the manual?
Questions and answers