Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ATrack AU5
Summary of Contents for ATrack AU5
-
Page 1: User Manual
AU5(i) User Manual Revision: 01 Revision Date: 2011/08/02 ATrack Technology Inc. Tel: +886-2-27975852 9F, No. 285, Sec. 2, Tiding Blvd., Fax: +886-2-27974030 Neihu Dist., Taipei City 11493, Taiwan (R.O.C.) http://www.atrack.com.tw... -
Page 2: Table Of Contents
Firmware Upgrade ......................... 6 3.1. Firmware Upgrade by serial connection ..................6 4. Appendix ..........................13 4.1. Hardware Specification ......................13 4.2. FCC Regulations: ........................14 © ATrack Technology Inc. All Rights Reserved. Page 2 of 14... -
Page 3: Notification
ATrack Technology Inc. products shall be avoided. ATrack Technology Inc. holds all parts of intellectual rights applicable in the copyright laws in all the countries. Any or all parts of this document shall not be exposed to non-authorized party without any form of approval from ATrack Technology Inc. -
Page 4: Hardware
Each package contains the following device/accessories: • Device * 1 • GSM/UMTS Antenna * 1 • GPS Antenna * 1 • Power/IO Cable * 1 • Serial Cable * 1 © ATrack Technology Inc. All Rights Reserved. Page 4 of 14... -
Page 5: Pin Assignments
Analog Input: 0 ~ 40 V; 10-bit Resolution. All outputs are open collector type (grounded when enabled). DO NOT CONNECT ANY POWER SOURCE TO 1-WIRE IO AND 1-WIRE GND TO AVOID DAMAGE. © ATrack Technology Inc. All Rights Reserved. Page 5 of 14... -
Page 6: Firmware Upgrade
Confidential Document (1) Run HyperTerminal program © ATrack Technology Inc. All Rights Reserved. Page 6 of 14... - Page 7 Confidential Document (2) Enter a name for the connection (3) Choose COM port and click [Configure…] button. © ATrack Technology Inc. All Rights Reserved. Page 7 of 14...
- Page 8 Confidential Document (4) Choose 57600,8,N,1 None flow control properties and click [OK] button. (5) Click [File] [Properties] © ATrack Technology Inc. All Rights Reserved. Page 8 of 14...
- Page 9 Confidential Document (6) Click [Settings] tab and [ASCII Setup…] button (7) Checked the following option and click [OK] button © ATrack Technology Inc. All Rights Reserved. Page 9 of 14...
- Page 10 Confidential Document (8) Power ON the device. The startup message will show on the screen. (9) Type “AT$FWDL” command and press [Enter] key. Choose [Transfer] [Send File…] © ATrack Technology Inc. All Rights Reserved. Page 10 of 14...
- Page 11 Confidential Document (10) Choose the firmware filename which is provided by ATrack and select [Ymodem] Protocol option and click [Send] button. (11) When [Send] button is clicked, the file transfer progress will show as below: © ATrack Technology Inc. All Rights Reserved.
- Page 12 Confidential Document (12) When file sending is completed, the device will program and restart itself automatically. © ATrack Technology Inc. All Rights Reserved. Page 12 of 14...
-
Page 13: Appendix
57600, 115200 bps 1-Wire (AT5i ONLY) Environmental Characteristics Operation Temperature -30 ~ +65°C (Note: Temp. up to +85°C with extreme condition) Storage Temperature -40 ~ +85°C Relative Humidity 5 ~ 95% © ATrack Technology Inc. All Rights Reserved. Page 13 of 14... -
Page 14: Fcc Regulations
FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation. © ATrack Technology Inc. All Rights Reserved. Page 14 of 14...
Need help?
Do you have a question about the AU5 and is the answer not in the manual?
Questions and answers