Fanimation WR506WH Specification And Instruction Sheet

WR506WH Wall Control
SPECIFICATION and INSTRUCTION SHEET
DESCRIPTION: 3-speed ceiling fan control with light dimmer switch and canopy receiver.
ELECTRICAL SPECS: AC 120V, 60Hz Ceiling Fan
FAN MODELS USED: most Fanimation fans - see catalog or visit our website, fanimation.com for
more information.
How to Wire and Operate Your Wall Control
BLACK (AC IN L)
GROUND WIRE
GREEN / YELLOW
BLACK (TO MOTOR L)
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If fan or supply wires are different colors than
indicated, have this unit installed by a qualified electrician.
1. If fan and/or light kit are controlled by a pull chain, fan
must be set to high and light kit must be switched on.
2. Install Receiver in the Hanger Bracket:
• Connect wires using connectors as shown in Figure 1.
• Position all connected wires and receiver antenna to
allow installation of ceiling canopy. (Figure 2)
• Using canopy screws threaded into the hanger bracket
reinstall ceiling canopy.
3.
Attach wall control unit to outlet box using the two
screws provided. Then, attach face plate to the wall
control. (Figure 3)
AC POWER
120V, 60HZ
L1 L
BLACK (AC IN L)
BLACK
(AC IN L)
N
WHITE (AC IN N)
BLUE (FOR LIGHT)
BLACK (TO MOTOR L)
WHITE (TO MOTOR N)
Figure 1
WHITE (AC IN N)
WHITE
(TO MOTOR N)
BLACK
(TO MOTOR L)
BLUE
( FOR LIGHT)
RF ANTENNA
BLUE
BLACK
WHITE
BLACK (AC IN L)
Figure 2
RF ANTENNA