Related Manuals for Maxon IDX 56
Summary of Contents for Maxon IDX 56
- Page 1 Quick Installation Guide IDX Drives Quick Installation Guide CCMC | Edition 2021-09 | DocID rel10409 This datasheet has been downloaded from http://www.digchip.com at this page...
-
Page 2: General Information
For in-depth information, for specifications, and for particular details on the device, consult the respective IDX drive’s user manual. You can access the full documentation in maxon’s software «EPOS Studio» or download it ... -
Page 3: Intended Use
Take this fact into consideration when the drive unintentionally ceases operation. For the operating temperature range of the mounted gear and brake consult the data sheet in the maxon catalog. Consider the lowest temperature of the individual components and reduce the motor’s output to meet the specified temperature limits. - Page 4 General Information About the Safety Precautions About the Safety Precautions Do not engage with any work unless you possess the stated skills. Make sure that you observe any regulation with regard to health, safety, and accident prevention as well as to environmental protection applicable in your country and at the site of imple- mentation.
- Page 5 – and be kept – in a safe operating mode. • Be aware that you are not entitled to perform any repair on components supplied by maxon. Improper handling or exceeding forces and loads can cause irreversible hardware damage •...
- Page 6 The subsequent information contains these notations: [a] = adapter M8/M12, A-coded, pinning as to CiA 303 / [b] = cable with open end / [c] = cable with connector / six-digit numbers represent maxon part numbers CANOPEN AND ETHERCAT INTERFACE...
-
Page 7: Encoder Interface
Connections POWER PLUG (WITHOUT ELECTRONICS) Power (IDX 56) Power (IDX 70) M12, male, 5 poles, L-coded M23, male, 6 poles, N-coded Connector Pin 1 Pin 2 Pin 3 Pin 4 UBrake + (optional) UBrake + (optional) Pin 5 UBrake GND (optional) - Page 8 (such as, but not concluding; malfunction of the device and/or attached equipment, loss of production, etc.) caused by incompatibility of firmware versions and/or by mis- match of a particular firmware version with a given hardware version! REQUIREMENTS FOR THE INSTALLATION OF «EPOS STUDIO»...
Need help?
Do you have a question about the IDX 56 and is the answer not in the manual?
Questions and answers