Setting Avr; Recording; Avr Setting; Avr Level - RCA RP5050 - Digital 128 MB Built Manual De L'utilisateur

RP5050 EN 18/10/06

Setting AVR

You can select between two
recording modes - manual recording
and AVR (Automatic Voice
Recording). Default AVR setting is off
and the AVR Level is 5.
AVR (Automatic Voice Recording)
This feature allows the player to
sense sound and to record only when
you are speaking into the
microphone. When dictation stops
for about 3 seconds, recording will
stop and then start again
automatically when you resume
dictation.
Tip:
The first syllable or two may be lost
when you start recording because this
'sound' is used to turn on the AVR
feature. It is a good practice to make
some 'sounds' or say a short word to
activate the AVR before you begin actual
dictation.

AVR Setting

1. In Main Menu Mode, press
to select Record Menu and press
to confirm your selection.
2. Press or
press to confirm your selection.
3. Press or
On and Off.
4. Press or MENU to save and exit
the current option.
11:16 AM
or
to select AVR and
to toggle between
Page 16
5. Press to enter AVR mode.
"AVR" will be displayed.
6. During AVR on
recording, you can
also adjust the
sensitivity of the
microphone from
level 1 to 8 by
pressing or .
The AVR value displays .
7. Start dictation. Recording starts
automatically.
8. Press to end AVR recording.
9. Repeat step 2-4 and select AVR off
for de-selection.

AVR Level

You can adjust the AVR value before

recording.

1. In Main Menu Mode, press
to select Record Menu and press
to confirm your selection.
2. Press or to
select AVR Level
and press to
confirm your
selection.
3. Press or to adjust the
sensitivity of the microphone from
level 1 to 8.
4. Press to enter AVR mode
Start dictation. Recording starts
automatically.
Note:
Decrease the AVR value and thus
the sensitivity when the recording
environment is noisy and vice versa.
EN
or
12