A-Tach Mounts 50696 Quick Start Manual

A-Tach # 50696
Designed for: Kia Sportage 2017 - 2019
Once the mount and holder are screwed together, the items are considered used and non-refundable.
For best results, attach the mount or hold the mount over the place where the mount attaches to the dash
BEFORE attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most
often the mount will appear to be a little too big or small for the intended location. Once attached, the
mount should remain attached until you would like to permanently remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
Online instruction can be found on the product page – Or at link:
https://www.atachmounts.com/assets/images/PDF%20-%20Instructions/50696%20-%20Instructions.pdf
(1) Clean the area where the mount will be attached. The
front edge of the mount will attach into the seam between
the padded dash top and speaker grill illustrated with the
arrow in the photo above.
(3) Use the seam tool to open the front seam. This will be a
tight seam so use two seam tools if needed.
NOTICE: The product has been tested to fit securely
to the listed vehicles. Instructions are provided for
your convenience. You are responsible for the use of
the product and determine if you have the skill to
attach the product without causing damage to your
vehicle or the product.
A-Tach Mounts will not be responsible for any damage
to the vehicle due to the installation and/or use of the
product.
Read all the instructions and view the photos before
attaching this product.
See additional instructions on the back side.
ST-2
(2) The lower edge of the mount will attach into the seam
between the padded dash top and the top frame around
the vent illustrated with the arrow in the photo above.
(4) Press the notched front edge of the mount into the
seam. The mount should hook onto the speaker grill.
A-Tach
Mounts