CTC Union ConnectBridge ACCESS360 Troubleshooting Manual
Hide thumbs
Also See for ConnectBridge ACCESS360:
- Troubleshooting manual (5 pages) ,
- Operational manual (21 pages)
Related Manuals for CTC Union ConnectBridge ACCESS360
Summary of Contents for CTC Union ConnectBridge ACCESS360
- Page 1 ACCESS360 ACCESS360 ConnectBridge™ Gateway ConnectBridge™ Gateway Troubleshooting Guide Troubleshooting Guide...
- Page 2 Table of Contents • Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 •...
-
Page 3: Introduction
Introduction The ACCESS360 functions as a network controller and Bluetooth® gateway that facilitates bi-directional data transfer with CTC Connect Wireless Sensors within range . ACCESS360 can accept an unlimited number of sensor inputs with 20 concurrent Bluetooth® connections at one time . Rated IP67, the ACCESS360 can withstand harsh environments including temperatures ranging from -4 °F to 158 °F (-20 °C to 70 °C) . -
Page 4: Troubleshooting
Troubleshooting Gateway is not powering on Ensure the power sourcing equipment complies with PoE IEEE standards Check the power-sourcing device is not set to a passive powering mode Inspect cabling for correct wiring or breaks The status light on the gateway is continually flashing orange This indicates there is no network communication . -
Page 5: Maintenance
Performing a factory reset Remove lid Press and hold the button marked “ETH Boot” Wait until the LEDs turn off and back on Reinstall the lid Transfer data to the new gateway Power off gateway Remove lids from both gateways Place the SD card from the old gateway into the new gateway Reinstall the lid Maintenance...
Need help?
Do you have a question about the ConnectBridge ACCESS360 and is the answer not in the manual?
Questions and answers