Selecting The Ntsc/Pal Signal System - JVC BR-DV3000U - Professional Editing Video Cassete recorder/player Instruction Manual

Dv video cassette recorder

Hide thumbs Also See for BR-DV3000U - Professional Editing Video Cassete recorder/player:

Instruction manual (38 pages)

Information sheet (1 page)

Quick manual (13 pages)

Table Of Contents

Table of Contents

PREPARATION

This unit supports both the NTSC and PAL signal system.

Before inputting analogue signals (composite or YC separate video signals), please select the

signal system.

OPERATE

button

OPERATE

A.DUB

Mini

PROFESSIONAL

MIC

REMOTE SEL.

INPUT SEL.

SERIAL

LINE

9PIN

WIRELESS

Y/C

Steps

Set the unit to the OPERATE OFF mode.

Please select the signal system with the NTSC/PAL switch on the rear panel.

Press the OPERATE button to engage the OPERATE ON mode. Either the NTSC or

PAL indicator on the front will then light up, according to the NTSC/PAL switch set-

ting.

Memo

• In the playback mode, the signal system of the tape is automatically identified, regardless of the

NTSC/PAL switch setting.

• During DV signal input, the signal system of the input signal is automatically identified, regardless

of the NTSC/PAL switch setting.

• This unit is equipped with a function to automatically detect the signal system of the cassette being

played back or the signal being received at the DV input connector. However, this function may not

operate correctly in some instances.

To ensure the correct system selection, it is recommended that you match the rear panel's NTSC/

PAL switch to the signal system of the input signal or playback tape.

• When the unit enters the STOP mode, the NTSC/PAL switch setting will be engaged.

• If a tape recorded in both NTSC & PAL signal systems is played, the video, audio or time code may

be distorted at the position where the signal system is switched.

• When the signal system of the tape and the NTSC/PAL setting differ, video and sound output will be

upset for about 5 seconds after playback starts or stops.

• NTSC/PAL signal system conversion is not possible.