Troubleshooting (Pump/Engine) ......27 Explanation Of Code In Remarks Column ....28 Suggested Spare Parts ..........29 Pump Assy............30-33 Specification and part number NOTE are subject to change without notice PAGE 4 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
Potential hazards associated with the QP-201TE Trash Pump injury. operation will be referenced with Hazard Symbols which appear throughout this manual, and will be referenced in conjunction with Safety Message Alert Symbols. PAGE 6 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
Page 7
ALWAYS wear approved eye and hearing protection. This pump, other property, or the surrounding environment could be NOTE damaged if you do not follow instructions. QP-201TE TRASH PUMP — PARTS MANUAL— REV. 0 (12/15/03) — PAGE 7...
Multiquip for this equipment. Damage to the equipment and/or injury to user may result. ■ Manufacturer does not assume responsibility for any accident due to equipment modifications. PAGE 8 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
Page 9
■ ALWAYS fill the pump casing with water before starting the engine. Failure to maintain water inside the pump housing will cause severe damage to the pump. ■ In winter drain water from pump housing to prevent freezing. QP-201TE TRASH PUMP — PARTS MANUAL— REV. 0 (12/15/03) — PAGE 9...
Page 10
. t f . 7 ( ) s r ( . t ) s r . n i ) . g Figure 1. QP-201TE Dimensions PAGE 10 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
Page 11
. s t e t i l ) s r l o r r t n u f i - y l . n i ) . g QP-201TE TRASH PUMP — PARTS MANUAL— REV. 0 (12/15/03) — PAGE 11...
Page 12
NEVER place the pump on soft soil . The suction hose or pipe connection should always be checked for tightness and leaks. A small suction leak in the hose or fittings could prevent the pump from priming. PAGE 12 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
QP-201TE — PUMP COMPONENTS Figure 2 shows a typical application using the QP-201TE Trash pump. Please note that this pump is intended for the removal of clean water and water containing some debris and solids. Maximum size of solids should not exceed 1-inch (25 mm) in diameter.
3. When refueling, be sure to use a strainer for filtration. DO NOT top-off fuel. Wipe up any spilled fuel immediately! Figure 4. Engine Oil Dipstick (Removal) QP-201TE TRASH PUMP — PARTS MANUAL— REV. 0 (12/15/03) — PAGE 15...
Place hose so that it lays as straight as it is possible on the ground. Remove any twists or sharp bends from hose which may block the flow of water. PAGE 16 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
5. Place the engine ON/OFF switch (Figure 10) in the " ON " position. Figure 7. Throttle Lever (1/3 Start Position) Figure 10. Engine ON/OFF Switch (ON Position) QP-201TE TRASH PUMP — PARTS MANUAL— REV. 0 (12/15/03) — PAGE 17...
Page 18
Emergency Showdown 1. Move the throttle lever quickly to the IDLE position, and place Figure 13. Throttle Lever (Run) the engine ON/OFF switch in the OFF position. PAGE 18 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
Page 20
This prevents backflow and allows for faster priming when the engine is restarted. PAGE 20 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
Page 21
QP-201TE — MAINTENANCE (PUMP) Pressure reading may vary depending on altitude. See Tables 3 NOTE and 4 on page 12. Figure 17. Pump Vacuum Tester QP-201TE TRASH PUMP — PARTS MANUAL— REV. 0 (12/15/03) — PAGE 21...
Page 22
. s l Reference manufacturer engine NOTE manual for specific servicing instructions. PAGE 22 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
(new or used) through the discharge opening on the pump and crank the engine several times. This will prevent excessive corrosion and also keep the mechanical seal lubricated. PAGE 24 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
, belong to the same assembly or kit. If more than one of the same reference number is listed, the NOTE last one listed indicates newest (or latest) part avaliable. PAGE 28 — QP-201TE TRASH PUMP — PARTS MANUAL — REV. #0 (12/15/03)
1 .... 0641360010 ..FUEL FILTER, GAS TANK Part number on this Suggested NOTE Spare Parts List may super cede/ replace the P/N shown in the text pages of this book. QP-201TE TRASH PUMP — PARTS MANUAL— REV. 0 (12/15/03) — PAGE 29...
Page 31
SEAL WASHER M8 0131151235 CAP SCREW (CASING) M12 X 35 0135051235 CAP SCREW SET W/ SEAL RING M12 X 35 0135051295 CAP SCREW SET W/ SEAL RING M12 X 95 QP-201TE TRASH PUMP — PARTS MANUAL— REV. 0 (12/15/03) — PAGE 31...
OPERATION AND PARTS MANUAL HERE'S HOW TO GET HELP PLEASE HAVE THE MODEL AND SERIAL NUMBER ON-HAND WHEN CALLING MULTIQUIP’S MAIN PHONE NUMBERS 800-421-1244 FAX: 310-537-3927 310-537-3700 PARTS DEPARTMENT 800-427-1244 FAX: 800-672-7877 310-537-3700 FAX: 310-637-3284 MAYCO PARTS 800-306-2926 FAX: 800-672-7877 310-537-3700 FAX: 310-637-3284 SERVICE DEPARTMENT...
Need help?
Do you have a question about the QP-201TE and is the answer not in the manual?
Questions and answers