Subscribe to Our Youtube Channel
Related Manuals for MQ Multiquip QP3TS
Summary of Contents for MQ Multiquip QP3TS
- Page 1 OPERATION MANUAL MODEL QP3TS TRASH PUMP (HONDA GX270RT2QMTR280 GASOLINE ENGINE) Revision #0 (03/02/20) THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.
- Page 2 TO PURCHASE THIS PRODUCT PLEASE CONTACT US Equipment Financing and Extended Warranties Available Discount-Equipment.com is your online resource for commercial and industrial quality parts and equipment sales. 561-964-4949 visit us on line @ www.discount-equipment.com Select an option below to find your Equipment We sell worldwide for the brands: Genie, Terex, JLG, MultiQuip, Mikasa, Essick, Whiteman, Mayco, Toro Stone, Diamond Products, Generac Magnum, Airman, Haulotte, Barreto, Power Blanket, Nifty Lift, Atlas Copco, Chicago Pneumatic, Allmand, Miller Curber, Skyjack, Lull,...
-
Page 3: Proposition 65 Warning
PROPOSITION 65 WARNING PAGE 2 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) -
Page 4: Table Of Contents
Maintenance (Pump) ........20-21 Maintenance (Engine) ........22-24 Storage ..............24 Troubleshooting (Engine) ........25 Troubleshooting (Pump) ........26 NOTICE Specifications and part numbers are subject to change without notice. QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 3... -
Page 5: Safety Information
COULD result in DEATH or SERIOUS INJURY. CAUTION Indicates a hazardous situation which, if not avoided, COULD result in MINOR or MODERATE INJURY. NOTICE Addresses practices not related to personal injury. PAGE 4 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) - Page 6 Also, know the phone numbers of the nearest ambulance, doctor and fi re department. This information will be invaluable in the case of an emergency. QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 5...
- Page 7 „ ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children and unauthorized personnel. PAGE 6 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20)
- Page 8 „ ALWAYS keep battery cables in good working condition. from fuel vapors or if fuel is spilled on a Repair or replace all worn cables. hot engine. QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 7...
- Page 9 „ Use lift points and lift straight upwards. LIFT LIFT POINT LIFT POINT „ DO NOT lift machine to unnecessary heights. „ ALWAYS tie down equipment during transport by securing the equipment with rope. PAGE 8 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20)
-
Page 10: Specifications (Pump)
41 psi (283 kPa) Dry Net Weight 282 lbs. (128 Kg.) 43.1 IN 28.9 IN (1094 MM) (735 MM) 30.6 IN (778 MM) Figure 1. QP3TS Dimensions QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 9... -
Page 11: Specifications (Engine)
Suction : 3 Inch Discharge : 3 Inch TOTAL HEAD 3.3 FT 10 FT 16.7 FT 23.3 FT METERS GALS/MIN LITERS/MIN 1000 1500 Figure 2. QP3TS Performance Curve PAGE 10 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) -
Page 12: General Information
4,000 (1,219) line as short as possible. In general always place the pump 6,000 (1,829) as close to the water as possible. 8,000 (2,438) 10,000 (3,048) QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 11... -
Page 13: Pump Components
PUMP COMPONENTS Figure 3. QP3TS Key Components PAGE 12 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) - Page 14 For quick disconnect connections, an optional can damage pump. coupler (A300A) is necessary. Contact MQ Parts Department for ordering assistance. QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 13...
-
Page 15: Cart And Engine Components
CART AND ENGINE COMPONENTS Figure 4. Cart and Engine Components PAGE 14 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) - Page 16 To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the heat exchanger removed. QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 15...
-
Page 17: Inspection (Engine)
Figure 5. Engine Oil Dipstick 3. When refueling, be sure to use a strainer for filtration. DO NOT top-off fuel. Wipe up any spilled fuel immediately! PAGE 16 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) -
Page 18: Setup
Figure 7. Pump Placement QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 17... -
Page 19: Operation
8. To begin pumping, place the throttle lever in the HIGH position. If water is not flowing out of the discharge port, turn off the engine and check for and clear any obstructions within the suction hose. PAGE 18 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) - Page 20 2. After the engine cools, turn the engine starter switch to the OFF position. Emergency Shutdown 1. Move the throttle knob quickly to the LOW position, and place the engine starter switch to the OFF position. QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 19...
-
Page 21: Maintenance (Pump)
This prevents backflow and allows for faster priming when the engine is restarted. PAGE 20 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) - Page 22 25 IN. HG TRANSLATES INTO 25 FEET OF LIFT ACCEPTABLE READING AT SEA LEVEL SHOULD BE BETWEEN -25 AND -20 IN. HG PUMP VACUUM TESTER Figure 12. Pump Vacuum Tester QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 21...
-
Page 23: Maintenance (Engine)
Refer to the HONDA shop Manual for service procedures. 3. For commercial use, log hours of operation to determine proper maintenance intervals. NOTICE Refer to manufacturer engine manual for specific servicing instructions. PAGE 22 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) - Page 24 ENGINE OIL RUBBER GROMMET FOAM ELEMENT SEALING WASHER SQUEEZE SOLVENT THOROUGHLY DRAIN BOLT Figure 15. Cleaning Foam Element Figure 13. Engine Oil (Draining) QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 23...
-
Page 25: Storage
(new or used) through the discharge opening on the pump and crank the engine several times. This will prevent excessive corrosion and also keep the mechanical seal lubricated. PAGE 24 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) -
Page 26: Troubleshooting (Engine)
Adjust governor to correct lever. Governor spring defective? Clean or replace ignition. Rotational speed fluctuates. Fuel flow erratic? Check fuel line. Air taken in through suction line? Check suction line. QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 25... -
Page 27: Troubleshooting (Pump)
Impeller does not turn; Adjust clearance by removing shim from Impeller and volute binding? pump is hard to start. behind impeller. Defective engine? See Engine Owner's Manual. PAGE 26 — QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) - Page 28 TO PURCHASE THIS PRODUCT PLEASE CONTACT US Equipment Financing and Extended Warranties Available Discount-Equipment.com is your online resource for commercial and industrial quality parts and equipment sales. 561-964-4949 visit us on line @ www.discount-equipment.com Select an option below to find your Equipment We sell worldwide for the brands: Genie, Terex, JLG, MultiQuip, Mikasa, Essick, Whiteman, Mayco, Toro Stone, Diamond Products, Generac Magnum, Airman, Haulotte, Barreto, Power Blanket, Nifty Lift, Atlas Copco, Chicago Pneumatic, Allmand, Miller Curber, Skyjack, Lull,...
- Page 29 OPERATION MANUAL HERE’S HOW TO GET HELP PLEASE HAVE THE MODEL AND SERIAL NUMBER ON-HAND WHEN CALLING Your Local Dealer is:...
Need help?
Do you have a question about the QP3TS and is the answer not in the manual?
Questions and answers