Advertisement
Quick Links
15 R
M
Mains
Energiser
M
CYCLIC WAVE
100-240 V
Warning: Read all instructions
Save these instructions
M15R M20R M36R Mains Energiser
20 R
Mains
TM
Energiser
CYCLIC WAVE
TM
User Manual
CYCLIC WAVE
TM
CYCLIC WAVE
TM
36 R
M
Mains Energiser
®
M15R / M15RE
M20R / M20RE
M36R / M36RS / M3 6RE
i n n o v a t i o n
t e c h n o l o g y
p e r f o r m a n c e
p o w e r
Advertisement
Related Manuals for Stafix M15R
Summary of Contents for Stafix M15R
- Page 1 ® User Manual M15R M20R M36R Mains Energiser M15R / M15RE M20R / M20RE M36R / M36RS / M3 6RE 15 R Mains 20 R Energiser Mains CYCLIC WAVE Energiser CYCLIC WAVE CYCLIC WAVE CYCLIC WAVE 36 R Mains Energiser...
- Page 2 The Remote Control Fence Compass..........2 © Tru-Test Limited, 2003-2006. All rights reserved. Communication between the energiser and the Remote Stafix, Remote Control Fence Compass and Cyclic Wave are trademarks of Tru- Test Corporation Limited. Control Fence Compass ................4...
- Page 3 An electric fence is not only a physical barrier, but is also a strong psychological barrier. Congratulations on your purchase of a Stafix energiser. This product has been constructed using the latest technology and What are the benefits of an electric fence? construction techniques.
- Page 4 The Remote Control Fence Compass The Remote Control Fence Compass is three tools in one. It acts as a: • Remote control – Switching the energiser on or off from a remote location anywhere on the electric fence system • Fault finder –...
- Page 5 Live fence alert tone Using the fault finder When the fence wire is in the Fence wire voltage slot or the Current flows through the path of least resistance. If the fence Fence wire remote slot, the Remote Control Fence Compass has a short circuit, more current will flow.
- Page 6 Changing the energiser's address setting Communication between the energiser and the Remote To switch to the Standby mode: Control Fence Compass Switch off the power supply to the energiser and wait for the red power light to stop illuminating, then switch on the power supply again.
- Page 7 Standby mode with only the large, green light Fences can be constructed to suit the type of livestock and on the right flashing. materials available. Discuss with your Stafix distributor which Press to switch off the remote control.
- Page 8 Connecting lead – An electric conductor, used to connect the Drive Stafix earth rods into the ground. Use high-voltage, energiser to the electric fence or the earth electrode. insulated cable and earth clamps to continuously connect the Electric animal fence –...
- Page 9 conductors of the electric fence. Physical barriers are typically be made underneath the power line and as nearly as possible constructed from vertical sheeting, rigid vertical bars, rigid at right angles to it. mesh, rods or chainwire mesh. If connecting leads and electric animal fence wires are Public access area –...
- Page 10 Measure the voltage across the energiser terminals with a Stafix Fence Compass, DVM or Lite Tester. If The energiser sometimes turns off unexpectedly the voltage is less than 6 kV, request your Stafix service agent • An adjacent property may have an energiser operating at to check the energiser.
- Page 11 Stafix-appointed service agent for repair. If the workmanship for a period from the date of purchase. If a supply cord is damaged it must only be replaced by a Stafix- warranted defect occurs, return this product with proof of appointed service agent, as a special cord is required.
- Page 12 ® w w w . s t a f i x . c o m Warning: Read all instructions Save these instructions...
Need help?
Do you have a question about the M15R and is the answer not in the manual?
Questions and answers