Craftsman 21914 - 12 in. Drill Press Operator's Manual page 4

[] DONOTUSE
TOOL IF SWITCH DOES NOT TURN IT
ON AND OFF. Have defective switches replaced by an
authorized service center.
[] ALWAYS TURN SWITCH OFF before disconnecting it
to avoid accidental starting.
[] NEVER USE iN AN EXPLOSIVE ATMOSPHERE.
Normal sparking of the motor could ignite fumes.
[] iNSPECT TOOL CORDS PERiODiCALLY. If damaged,
have repaired by a qualified service technician at an
authorized service facility. The conductor with
insulation having an outer surface that is green
with or without yellow stripes is the equipment-
grounding conductor. If repair or replacement of the
electric cord or plug is necessary, do not connect the
equipment-grounding conductor to a live terminal.
Repair or replace a damaged or worn cord
immediately. Stay constantly aware of cord location
and keep it well away from the rotating blade.
[] iNSPECT EXTENSION CORDS PERiODiCALLY and
replace if damaged.
[] GROUND ALL TOOLS. If tool is equipped with three-
prong plug, it should be plugged into a three-hole
electrical receptacle.
[] USE ONLY CORRECT ELECTRICAL DEVICES: 3-wire
extension cords that have 3-prong grounding plugs
and 3-pole receptacles that accept the tool's plug.
[] KEEP TOOL DRY, CLEAN, AND FREE FROM OiL
AND GREASE. Always use a clean cloth when clean-
ing. Never use brake fluids, gasoline, petroleum-based
products, or any solvents to clean tool.
[] NEVER START A TOOL WHEN ANY ROTATING
COMPONENT iS iN CONTACT WiTH THE
WORKPIECE.
[] DO NOT OPERATE A TOOL WHILE UNDER THE
iNFLUENCE OF DRUGS, ALCOHOL, OR ANY
MEDiCATiON.
[] WHEN SERViCiNG use only identical replacement
parts. Use of any other parts may create a hazard or
cause product damage.
[] USE ONLY RECOMMENDED ACCESSORIES listed in
this manual or addendums. Use of accessories that are
not listed may cause the risk of personal injury. Instruc-
tions for safe use of accessories are included with the
accessory.