Razor W15128001164 Manual

Rsf350 e-kit replacement

Download this manual

Required Tools: (Not included)

• Phillips screwdriver

• 10 mm wrench

• Wire cutters

WARNING

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these

steps in the correct order may cause irreparable damage.

Step 1

Using a Phillips screwdriver, loosen and remove seven (7)

screws from the battery cover on the side with the

charger port.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.

• 3 mm Allen wrench

• 4 mm Allen wrench

• Small flat screwdriver

PART NUMBER: W15128001164

Step 2

Using a 10 mm wrench, loosen and remove the two (2)

lock nuts under the seat. Lift and remove the seat from the

frame and set aside.

RSF350

E-KIT REPLACEMENT

Need help?

Do you have a question about the W15128001164 and is the answer not in the manual?

Page 1 Lift and remove the seat from the charger port. frame and set aside. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 2 "gas" tank and one (1) regular screw from the (2) regular screws from the steering tube. main frame. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 3 The other two wires from the controller connect to the silver-colored prongs and can be installed in any sequence. ATTENTION: Charge battery 12 hours before using. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time. 250429...