Craftsman 11580 - C3 19.2 Volt Hammer Operator's Manual page 15

USING THE AUXILIARY HANDLE ASSEMBLY
See Figures 12- 13.
An auxiliary handle is packed with the drill for ease of
operation and to help prevent loss of control. The handle
can be rotated 360 ° , and it can also be mounted on the
opposite side for left hand use.
To adjust the auxiliary handle assembly, loosen the handle
assembly by turning the handle counterclockwise.
Rotate the auxiliary handle assembly to the desired
operating position.
Securely tighten by turning the auxiliary handle clockwise.
Be sure the auxiliary handle is securely tightened against
the depth gauge clamp. This secures the depth stop rod
at the desired depth of cut. It also secures the auxiliary
handle.
NOTE: For convenience and ease of starting threads, the
hex nut has been trapped inside the molded slot in the
auxiliary handle.
The depth stop rod helps control the depth of drilled
holes.
NOTE: When properly installed, the teeth on the depth
stop rod should be aligned with the teeth indicator on the
depth gauge clamp.
Adjust the depth stop rod so that the drill bit extends
beyond the end of the rod to the required drilling depth.
When drilling holes with the depth stop rod installed, the
desired hole depth has been reached when the end of the
rod comes in contact with the surface of the workpiece.
HEXBOLT PLATE
AUXiLiARY
HANDLE
ADJUSTING THE AUXILIARY HANDLE ASSEMBLY
See Figure 13.
[] Loosen the auxiliary handle assembly by turning the
knob counterclockwise.
[] Rotate the auxiliary handle assembly to the desired
location.
[] Tighten the auxiliary handle assembly securely by turn-
ing the knob clockwise.
ADJUSTING THE DEPTH STOP ROD
See Figure 13.
[] Lock the switch trigger by placing the rotation selector
in the center position.
[] Loosen the auxiliary handle assembly by turning the
knob counterclockwise.
[] Adjust the depth stop rod so that the drill bit extends
beyond the end of the rod to the required drilling depth.
[] Tighten the auxiliary handle assembly by turning the
knob clockwise.
DEPTHSTOPROD
SCALE
TEETH
DRILL BIT
TO
INCREASE
DRILLING
DEPTH
HEXSLOT
HEX BOSS
'0i_?TO
TIGHTEN LOOSEN
TO DECREASE
DRILLING DEPTH
TO
TIGHTEN
DRiLLiNGDEPTH
F0
LOOSEN
Fig. 13
Fig. 12
15