Related Manuals for TECO TVF411WNA
Summary of Contents for TECO TVF411WNA
- Page 1 VERTICAL FREEZER FROST FREE USER’S MANUAL Model : TVF411WNA / TVF411SNA To ensure proper use of the appliance and your safety, please read the following user manual completely before operating this appliance.
- Page 2 The appliance has not been designed or manufactured for professional use. Teco declines all responsibility for damage deriving from improper use of the appliance. The freezer has undergone the necessary tests on the tightness of the refrigeration circuit and complies with the safety regulations for electrical appliances.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Safety precautions..........1 - 2 Name of parts and usage......... 3 Packing List ............ 4 Transporting the appliance ......5 Installation instructions........5 Door Handle Installation ........6 Installing the kick panel ........7 Control panel ........... 8 Operating instructions ........ -
Page 4: Safety Precautions
SAFETY PRECAUTIONS Instructions The refrigeration system behind and inside the freezer WARNING contains refrigerant. Do not allow any sharp objects to come in contact with the refrigerant system. Keep ventilation openings, in the appliance enclosure or in the built in structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. - Page 5 Containers with fl ammable gases or liquids can leak at low temperature. There is a risk of explosion. Do not store any container with fl ammable materials such as spray cans in the freezer. Do not operate any electrical appliance in the freezer (e.g.
-
Page 6: Name Of Parts And Usage
NAME OF PARTS AND USAGE 1. Internal Light Switch 6. Airfl ow Inlet 2. Internal Light Cover 7. Wire Drawer 3. Temperature Sensor 8. Door Rack(s) 4. Wire Shelve(s) 9. Wire Door Rack 5. Airfl ow Outlet 10. Kick Panel The freezer you purchased is subject to continuous improvement, which may not be completely consistent with the manual, however the functions and operating methods will not change. -
Page 7: Packing List
PACKING LIST Check the packing list that all items have been included. Part No. Model TVF411WNA (see pg.3) Wire Shelving 4 pieces Wire Drawer 2 pieces Kick Panel 1 piece Door Handle 1 piece 5 pieces Door Handle / Kick... -
Page 8: Transporting The Appliance
TRANSPORTING THE APPLIANCE 1.The appliance must be transported only in a vertical position. The packing must be intact during the transportation. 2. When unpacking and re-packing the appliance, please memorise the position of each accessory of the appliance when unpacking it. When re-packing the appliance for transportation, ensure all accessories are secured before transportation. -
Page 9: Door Handle Installation
DOOR HANDLE INSTALLATION The images below are for reference purposes and may differ from your freezer. The freezer must be disconnected from the mains power source before attempting to install the door handle. Hole Screw 1. Remove the allen key and two screws from the plastic bag supplied and install them into the door holes. -
Page 10: Installing The Kick Panel
INSTALLING THE KICK PANEL Open the door and remove the necessary items to install the kick panel (kick panel and screws). Install the kick panel onto the bottom beam of the freezer. Refer to the illustration below. Cover plate Remove the cover plate on the hinge side. -
Page 11: Control Panel
CONTROL PANEL ALARM LAMPS 1. High temperature alarm 2. Door open alarm (sounds when the door is left open for 60 seconds) BUTTONS 3. Temperature setting / quick freeze time setting down (decrease) 4. Temperature setting / quick freeze time setting up (increase) 5. -
Page 12: Operating Instructions
WARNING WARNING... -
Page 13: Energy Saving Tips
ENERGY SAVING TIPS 1. Adjust the temperature control to a setting that is acceptable for the storage of the food. This will reduce the power consumption. 2. Only open the door when required. Frequently opening the door will increase power consumption. 3. -
Page 14: Replacing The Internal Lamp
To replace the internal Fig. 1 lamp, follow these steps. NOTE: Before replacing the bulb, disconnect the appliance from the mains power. STEP 1. Open the freezer door and locate the lamp cover. Lamp cover Remove the two screws from the lamp cover STEP 2. -
Page 15: Disconnection Of The Appliance
DISCONNECTION OF THE APPLIANCE If a power failure occurs, even in summer, the freezer could store food normally for some time. 1. Power failure During a power failure, do not put additional food in the appliance and reduce opening the door frequently. Place several ice cubes into each freezer drawer if power failure is anticipated beforehand, and place it in the top of the freezer. -
Page 16: Troubleshooting
TROUBLESHOOTING The following cases are not malfunctions: 1. Moisture may form as condensation on the outside of the appliance during humid conditions. To remove excess moisture, wipe clean. 2. The fl ow of refrigerant through the pipeline coil could cause gurgling, similar to water boiling. -
Page 17: Repairs, Service & Warranty
IF SERVICE IS REQUIRED: If you have a problem, and the problem persists after you have made the checks mentioned above, contact: TECO Australia’s Service on 1300 660 037 For warranty details please visit www.teco.com.au Complete and retain the following information:... -
Page 18: Specifications
SPECIFICATIONS TVF411WNA / Model TVF411SNA Climate class Classifi cation of Class 1 installation and use Indoor use only Rated Total Gross Volume (L) Voltage (V) Frequency (Hz) Noise Level (dB) Refrigerant type R134a Max. Ambient Operating temp ( 1550 Height... - Page 19 MBD-PV1...
Need help?
Do you have a question about the TVF411WNA and is the answer not in the manual?
Questions and answers