Installing The Switch (Magnet Mount); Connecting To An Sfp Module - Cisco WS-C2940-8TT-S Hardware Installation Manual

Connecting to an SFP Module

Installing the Switch (Magnet Mount)

To mount a switch by using the magnet, follow these steps:
Place one side of the magnet against the bottom of the switch, as shown in
Step 1
Figure 2-7
2
1
2
Mount the magnet and switch on a metal surface.
Step 2

Connecting to an SFP Module

This section describes how to connect to an SFP module. For instructions about how to install or remove
an SFP module, see the Cisco Small Form-Factor Pluggable Modules Installation Notes (order number
DOC-7815160=) and to the documentation that came with your SFP module.
Do not remove the rubber plugs from the ports on fiber-optic SFP modules or the rubber caps from the
Caution
the fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP module
ports and cables from contamination and ambient light.
Before connecting to an SFP module, be sure that you understand the port and cabling stipulations in
Table 1-2
for information about the LC on the SFP modules for fiber-optic connections.
Catalyst 2940 Switch Hardware Installation Guide
2-12
Mounting the Switch with a Magnet
1
ES
RI SE 4 0
2 9
st al y
at
C
3
Desk 3 Switch
Magnet
and in the "SFP Module Slot" section on page
Figure 2-7
D
SP
LX
DP
T
STA
ST
SY
1-4. See Appendix B, "Connectors and Cables,"
Chapter 2 Installation
OL-6157-01