Installing the Switch
Figure 2-1
1
Screw template
2
Screws
Peel the adhesive strip off the bottom of the screw template, and attach it to the top of the desk.
Step 3
Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the two screw
Step 4
template slots.
Step 5
Insert three screws in the slots on the screw template, and tighten until they touch the top of the screw
template.
Remove the screw template from the desk top.
Step 6
Catalyst 2940 Switch Hardware Installation Guide
2-6
Installing the Mounting Screws on Top of a Desk
2
1
3
Wall
4
Desk
Chapter 2
2
4
Installation
3
OL-6157-01