Connecting The Drain Hose To The Drain - Beko BMM5DFO5741WPB User Manual

2. Tighten all hose nuts by hand. Never use
a tool when tightening the nuts.
3. Open the taps completely after making
the hose connection to check for water
leaks at the connection points. If any
leak occurs, turn off the tap and remove
the nut. Check the gasket and tighten
the nut carefully again. In order to pre-
vent the water leaks and resultant dam-
ages, keep the taps closed when you do
not use the product.
4.4 Connecting the Drain Hose to the
Drain
1. Connect one end of the water inlet hose
to a cold water tap and tighten by hand
(see figure). Before performing the
connection, allow the water to run freely
until it is perfectly clear.
2. Connect the other end of the water inlet
hose to the water inlet valve on the rear of
the appliance and tighten by hand.
3. Turn on the tap slowly and make sure
there are no leaks.
Do not twist, squash, modify or cut the
hose. Tighten the end of the hose firmly
by hand.
The supply water pressure must be in
0.03-1 MPa range. If the water pressure
exceeds this value, please fit a pressure
reducing valve.
If the hose is not long enough, contact
a specialized shop or an authorized
technician.
Never use a second-hand water inlet
hose. Use the new water inlet hose
supplied with the appliance.
4. Height difference between the floor
and drainage point should be minimum
60cm (24 in.) and maximum 100 cm
(39 in.)
EN / 17