Table of Contents
Advertisement
Quick Links
USER MANUAL
Darlington Play Centre
with 2.2m Slide
WARNING: The disassembled product may contain small parts
which pose a choking hazard to children under 3.
IMPORTANT:
This product may contain sharp points and small parts prior to assembly. The owner's manual contains
safety, assembly, use and maintenance instructions. This product must be assembled by an adult who
has read and understood these instructions. Keep the packaging away from children and dispose of all
packaging before use.
For the installer and your children's safety, it is important to fully read and understand the instructions
and safety hazards before commencing the assembly of the product.
NOTE:
This manual should not be used to guide your purchasing decision. Your product, and the contents
inside its carton, may vary from what is listed in this manual. This manual may also be subject to
updates or changes. Updated manuals are available through our website at www.lifespankids.com.au.
Find the Digital
Manual Online
Advertisement
Table of Contents
Related Manuals for LifeSpan Kids Darlington
Summary of Contents for LifeSpan Kids Darlington
- Page 1 USER MANUAL Darlington Play Centre with 2.2m Slide Find the Digital Manual Online WARNING: The disassembled product may contain small parts which pose a choking hazard to children under 3. IMPORTANT: This product may contain sharp points and small parts prior to assembly. The owner’s manual contains safety, assembly, use and maintenance instructions.
-
Page 2: Table Of Contents
TABLE OF CONTENTS I. GENERAL SAFETY INSTRUCTIONS 1.1 Danger for Children 1.2 Risk of Injuries 1.3 Product Damage 1.4 Assembly Advice II. SAFETY INSTRUCTIONS III. EXPLODED DIAGRAM IV. ASSEMBLY INSTRUCTIONS V. MAINTENANCE VI. FREQUENTLY ASKED QUESTIONS VII. WOOD ADVICE VIII. WARRANTY... -
Page 3: General Safety Instructions
I. GENERAL SAFETY INSTRUCTIONS NOTE: This product is intended for outdoor domestic use only. 1.1 DANGER FOR CHILDREN WARNING: No eating while using the product at the same time. • Children do not recognize potential dangers from this product. The unassembled product must be stored out of reach of children and pets. -
Page 4: Assembly Advice
1.4 ASSEMBLY ADVICE • The product should not be installed over concrete, asphalt or any hard surface. We recommend installing on grass area or dirt ground with playground wood-chips (mulch) or other impact absorbing ground cover on top (see page 6). •... -
Page 5: Safety Instructions
II. SAFETY INSTRUCTIONS A maximum of 68 kgs. per child is recommended for play activities designed for individual use. A maximum of 54 kgs. per child is recommended for play activities designed for multiple child use. A maximum of 9 children is recommended for this swing set. •... - Page 6 Consumer Information Sheet for Playground Surfacing Materials The US Consumer Product Safety Commission (CPSC) estimates that about 100 000 playground equipment-related injuries resulting from falls to the ground surface are treated annually in US hospital emergency rooms. Injuries involving this hazard pattern tend to be among the most serious of all playground injuries, and have the potential to be fatal, particularly when the injury is to the head.
-
Page 7: Exploded Diagram
III. EXPLODED DIAGRAM EXPLODED DIAGRAM... -
Page 8: Assembly Instructions
IV. ASSEMBLY INSTRUCTIONS B O A R D L I S T H1 = 1 H21 = 5 1230x86x16mm 852x100x16mm H22 = 1 H2 = 1 1230x76x16mm 882x100x16mm H23 = 1 H3 = 1 524x86x16mm 882x76x16mm H24 = 4 H4 = 1 852x76x16mm 905x86x16mm H5 = 14... - Page 9 F1 = 2 1314x86x24mm F2 = 1 1000x86x24mm F3 = 1 1734x86x24mm F4 = 1 1734x86x24mm F5 = 1 1000x86x24mm F6 = 1 1000x86x24mm F7 = 1 1734x86x24mm F8 = 1 1115x86x24mm F9 = 1 1000x86x24mm F10 = 2 1314x86x24mm F11 = 1 496x60x24mm F12 = 1...
- Page 10 F23 = 4 484x86x24mm F25 = 2 1212x85x24mm F26 = 1 1056x86x24mm F27 = 1 1892x86x24mm B1 = 1 2420x134x50mm B2 = 2 2159x76x50mm C1A = 1 2420x76x50mm C1B = 1 2420x76x50mm C2 = 2 2420x76x50mm C3 = 2 2420x76x35mm C4 = 2 832x76x35mm K1 = 1...
- Page 11 P A R T S L I S T W12/28 W10/18 N815 Washer x 6 Washer x 92 NUT x 102 BM818 B-NUT x 19 A-NUT8 x 6 SW16 S315 Screw x 10 Screw x 18 SW28 S321 Screw x 22 Screw x 6 SW35 S328...
- Page 12 (1) 139007 (2) L651003 (1) L651022 (1) L651023 (1) L651024 (6) 650007 (1) 139008 Star Bit (S) Star Bit (L) Allen Wrench (S) Allen Wrench (L) (4) 153003 (2) 139002 (3) 650051 (1) L650008 (1) 148001 (1) FBH-1 530mm x 340mm (2) L651015 Instructions (7) 139070...
- Page 13 STEP 1 N815 W10/18 M869 N815 W10/18 M855 M855 W10/18 M869 N815 ASSEMBLY INSTRUCTIONS...
- Page 14 STEP 2 N815 W10/18 M869 N815 W10/18 M855 M855 W10/18 M869 N815 ASSEMBLY INSTRUCTIONS...
- Page 15 STEP 3 N815 N815 W10/18 M896 M896 Note the orientation of the pilot holes M896 N815 W10/18 ASSEMBLY INSTRUCTIONS...
- Page 16 STEP 4 N815 W10/18 M896 Note the orientation of the pilot holes M896 N815 W10/18 ASSEMBLY INSTRUCTIONS...
- Page 17 STEP 5 SW50 SW50 ASSEMBLY INSTRUCTIONS...
- Page 18 STEP 6 N815 W10/18 M855 M6SW55 M6SW55 W10/18 N815 M855 ASSEMBLY INSTRUCTIONS...
- Page 19 STEP 7 SW60 SW60 SW60 ASSEMBLY INSTRUCTIONS...
- Page 20 STEP 8 M855 M6SW55 W10/18 N815 M6SW55 W10/18 N815 M855 ASSEMBLY INSTRUCTIONS...
- Page 21 STEP 9 SW35 SW35 SW35 ASSEMBLY INSTRUCTIONS...
- Page 22 STEP 10 N815 W10/18 N815 M896 W10/18 M896 SW35 SW35 SW35 W10/18 M896 N815 ASSEMBLY INSTRUCTIONS...
- Page 23 STEP 11 M845 M821 L651015 BM818 W10/18 L651015 N815 BM818 M821 N815 M845 W10/18 M845 W10/18 BM818 N815 M821 ASSEMBLY INSTRUCTIONS...
- Page 24 STEP 12 SW50 M821 BM818 ASSEMBLY INSTRUCTIONS...
- Page 25 STEP 13 139008 139007 SW16 SW16 ASSEMBLY INSTRUCTIONS...
- Page 26 STEP 14 SW35 SW35 SW35 ASSEMBLY INSTRUCTIONS...
- Page 27 STEP 15 SW50 ASSEMBLY INSTRUCTIONS...
- Page 28 STEP 16 SW50 ASSEMBLY INSTRUCTIONS...
- Page 29 STEP 17 SW50 SW50 SW50 ASSEMBLY INSTRUCTIONS...
- Page 30 STEP 18 W10/18 M855 N815 M855 N815 W10/18 ASSEMBLY INSTRUCTIONS...
- Page 31 STEP 19 SW35 ASSEMBLY INSTRUCTIONS...
- Page 32 STEP 20 75mm 77mm SW35 SW35 SW35 ASSEMBLY INSTRUCTIONS...
- Page 33 STEP 21 SW35 ASSEMBLY INSTRUCTIONS...
- Page 34 STEP 22 SW40 ASSEMBLY INSTRUCTIONS...
- Page 35 STEP 23 SW35 ASSEMBLY INSTRUCTIONS...
- Page 36 STEP 24 SW35 ASSEMBLY INSTRUCTIONS...
- Page 37 STEP 25 SW28 ASSEMBLY INSTRUCTIONS...
- Page 38 STEP 26 SW35 SW35 SW35 ASSEMBLY INSTRUCTIONS...
- Page 39 STEP 27 SW35 ASSEMBLY INSTRUCTIONS...
- Page 40 STEP 28 M896 W10/18 N815 M896 N815 W10/18 ASSEMBLY INSTRUCTIONS...
- Page 41 STEP 29 SW40 42mm SW40 ASSEMBLY INSTRUCTIONS...
- Page 42 STEP 30 N815 W10/18 M845 M845 N815 W10/18 ASSEMBLY INSTRUCTIONS...
- Page 43 STEP 31 SW35 ASSEMBLY INSTRUCTIONS...
- Page 44 STEP 32 SW35 SW35 SW35 SW35 SW35 ASSEMBLY INSTRUCTIONS...
- Page 45 STEP 33 S321 S321 S321 S321 ASSEMBLY INSTRUCTIONS...
- Page 46 STEP 34 N815 W12/28 SWING HANGER - 650007 N815 W12/28 Insert the N815 into the Insert the swing hanger beam by hammer into the beam and fix them with nuts N815 as tightly as possibly Fix the AN8 as tightly as possible W12/28 N815...
- Page 47 STEP 35 L651022 M845 M845 L651023 BM818 BM818 M845 BM818 M6SW35 ASSEMBLY INSTRUCTIONS...
- Page 48 STEP 36 N815 M896 W10/18 M896 W10/18 N815 ASSEMBLY INSTRUCTIONS...
- Page 49 STEP 37 BM818 M845 L651024 L651003 M869 BM818 BM818 M845 M845 M869 BM818 ASSEMBLY INSTRUCTIONS...
- Page 50 STEP 38 Hang the swing 139002 L650050 139002 139002 N815 M821 ASSEMBLY INSTRUCTIONS...
- Page 51 STEP 39 SW35 SW35 SW35 SW35 SW35 ASSEMBLY INSTRUCTIONS...
- Page 52 STEP 40 650051 S315 ASSEMBLY INSTRUCTIONS...
- Page 53 STEP 41 SW50 ASSEMBLY INSTRUCTIONS...
- Page 54 STEP 42 M6SW35 153003 M6SW35 M6SW35 ASSEMBLY INSTRUCTIONS...
- Page 55 STEP 43 L650008 S328 S328 S328 ASSEMBLY INSTRUCTIONS...
- Page 56 STEP 44 SW50 SW50 Put the slide braces T1 under the floor boards and fix the slide with floor and slide braces together L650001 SW50 ASSEMBLY INSTRUCTIONS...
- Page 57 STEP 45 M6SW35 139070 M6SW35 ASSEMBLY INSTRUCTIONS...
- Page 58 STEP 46 SW16 148001 x 1 FBH-1 x 1 SW16 SW16 ASSEMBLY INSTRUCTIONS...
-
Page 59: Maintenance
V. MAINTENANCE WARNING: Please keep for future reference. We recommend regular maintenance to be conducted at the beginning of each season as well as at regular intervals during the usage session for your play equipment to ensure all main parts/fixings are tightly secured, well-oiled and intact to avoid failure, injury or hazards. -
Page 60: Frequently Asked Questions
9. The end beam is not straight up and down. Why not? This is normal. Lifespan Kids designs playsets this way to ensure the strongest structure possible. The slight angle adds strength and reduces rocking and twisting. -
Page 61: Wood Advice
VII. WOOD ADVICE Our products are manufactured from premium timber. Great care is taken in selecting, machining, and treating the timber before it is sold to you. 1. Inspect wood parts monthly. The grain of the wood sometimes will lift in dry periods causing splinters to appear. - Page 62 WHEN SHOULD WOOD CRACKS BE A CONCERN? Most of the wood splits will never become large enough to affect the reliability and strength of our products, however, there can be rare cases where splits can occur. This happens when a crack develops past the halfway point from the timber, splitting it into two separate pieces.
-
Page 63: Warranty
If you have purchased this product from the Official Lifespan Kids website, please visit www.lifespankids.com.au/warranty-form For support outside of warranty, if you wish to purchase replacement parts or request a repair or service, please visit www.lifespankids.com.au/warranty-form and fill in our Repair/Service Request Form or... - Page 64 www.l i f e s p an k i d s . co m . a u...
Need help?
Do you have a question about the Darlington and is the answer not in the manual?
Questions and answers