Chevrolet TRACKER 2003 Manual page 108

3. Release the plastic strip sewn along the bottom
edge of the window by gently pulling down and
out. Then release the plastic along the front edge of
the window by pulling it forward and out. It may
help to rock the window back and forth to remove it.
4. Unfasten the plastic clip, which is part of the canvas
top, at the top front corner of each side window.
Then unzip the zipper the rest of the way and
remove the side window.
To install the side window:
1. Make sure the plastic clip at the top front corner of
2. Then start by zipping the zipper about 3 inches
the canvas top is unfastened.
(8 cm), to hold the window in place. When zipping,
place the rear bottom corner of the window inside the
rear part of the vehicle body to help support the
window while you engage the zipper end.
3. Install the plastic strip into the window channel
before completely zipping the window. There is
a locating pin in the front upper corner to assist in
aligning the window.
2-41