Advertisement
NEXT
Press this button
to go
forward to the beginning
of the next selection. Press the button again or press
RCL/PROG or EJECT to cancel this function.
For NEXT to work properly, your tape must have
at
least three or four seconds of silence between each
selection. If you press RCL/PROG, the tape will also
change sides.
PREV: Press this button to go back to the beginning of
the last selection. Press PREV again or press
RCL/PROG or EJECT to cancel this function.
RCL/PROG: Press this button to switch from one side
of the tape to the other. Your cassette tape player can
play continuously because the player has
an
auto-reverse feature.
Noise Reduction: Press the button with the double-D
symbol to remove noise from tapes encoded with
Dolby@
NR.
Dolby Noise Reduction is manufactured under a license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks
of
Dolby
Laboratories Licensing Corporation.
EJECT
Press this button to remove the tape and switch
to radio.
TAPE: Press this button when the radio is playing to
switch to tape play. To switch from the tape to the radio
when the tape is playing, press the AM-FM button.
R-M: Press this button to hear the radio when you are
fast forwarding or reversing a cassette tape. You can use
the
TUNE,
SEEK and PRESET SCAN buttons while in
the radio monitor mode.
CLN:
This message may appear on the display. If it
does, your cassette tape player needs to be cleaned.
It
will still play tapes, but you should clean
it
as soon as
possible to prevent damage to your tapes and player.
See "Care of Your Cassette Tape Player" in the Index.
After you clean the player, press and hold EJECT
for
five seconds to reset the CLN indicator. The radio will
display
---
to show the indicator was reset.
Advertisement
