DeLonghi Magnifica Evo ECAMFEB296 Series Instructions For Use Manual
DeLonghi Magnifica Evo ECAMFEB296 Series Instructions For Use Manual

DeLonghi Magnifica Evo ECAMFEB296 Series Instructions For Use Manual

Bean to cup espresso and cappuccino machine

Advertisement

Quick Links

ECAM29X.6Y - 29X.8Y EX:1 - FEB296X - 298X EX:1
BEAN TO CUP ESPRESSO AND
CAPPUCCINO MACHINE
Instructions for Use

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Magnifica Evo ECAMFEB296 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for DeLonghi Magnifica Evo ECAMFEB296 Series

  • Page 1 ECAM29X.6Y - 29X.8Y EX:1 - FEB296X - 298X EX:1 BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instructions for Use...
  • Page 2 A1 A1 A2 A2...
  • Page 3 Decalci cante per macchine da ca è Descaler for co ee machines Détartrant pour machines à café Entkalker für Ka eemaschinen De’Longhi Appliances s.r.l. Via L. Seitz, 47 31100 Treviso - ITALY Tel. +39 0422 4131 5413218631/04.15 ✕ ✕ ✕ ✓...
  • Page 4: Table Of Contents

    CONTENTS 13. CLEANING THE MACHINE ....15 1. INTRODUCTION ........5 14. THOROUGH CLEANING OF MILK CARAFE ..17 1.1 Letters in brackets ........5 15. CLEANING THE BREWING UNIT ....18 1.2 Troubleshooting and repairs ....5 16. DESCALING ........18 2. DESCRIPTION ......... 5 2.1 Description of the appliance - A ....5 17.
  • Page 5: Introduction

    D5. Hot water spout If repairs are required, contact De’Longhi customer services 2.5 Description of milk carafe - E only. Addresses can be found on the website www.delonghi. com. E1. Froth dial E2. Milk carafe lid 2.
  • Page 6: Setting Up The Appliance

    To ensure the performance of the machine remains constant over time, we recommend using a De’Longhi water softener filter. For more information, visit the www.delonghi.com website. EAN: 8004399327252 To use the filter correctly, follow the instructions below.
  • Page 7: Replacing The Filter

    2. To activate the filter, run drinking water through the hole to start filling up, expelling the air bubbles that have been formed and allowing the installation to proceed. in the centre of the filter until water comes out of the •...
  • Page 8: Turning The Appliance On

    3. Remove the strip from the water and shake lightly (fig. • unplug the power cord from the socket. 13). After about a minute, 1, 2, 3, or 4 red squares appear, 8. MAKING COFFEE DRINKS depending on the hardness of the water. Each square cor- responds to one level.
  • Page 9: Making 2 Cups Of Coffee

    8.4 General indications for making coffee- 5. Preparation begins and the Led corresponding to the se- lection blinks on the control panel (B). based drinks • Indicator lights may appear on the control panel (B) dur- 8.2 Making 2 cups of coffee ing use.
  • Page 10: Adjusting The Coffee Grinder

    9.1 What milk to use? • warm the cups with hot water, using the Hot Water function; The quality of the froth will vary depending on: • increase the coffee temperature (see section “12. Settings • the temperature of the milk or vegetable drink used (for menu”).
  • Page 11: Filling And Attaching The Milk Carafe

    • If there is insufficient milk in the carafe, the milk spout will produce a dry puff. 9.3 Filling and attaching the milk carafe 1. Press the release button (E4) and lift the lid (E2) (fig. 18); Lift Press 2. Select the milk-based drink from the control panel Please note: If“Energy Saving”...
  • Page 12: Customising The Quantity In The Cup

    • For the My Milk drink, only the quantity of coffee can be Leave the milk carafe in the machine (there is no need to empty programmed, while all the milk will be used as in the recipe. the container); 5.
  • Page 13: Settings Menu

    12. SETTINGS MENU Having accessed the menu, the buttons that remain active can be used to select the corresponding functions: Selection of Access/exit to Beep settings menu settings Water softener filter Auto-off Coffee temperature Energy saving Water hardness Drinks differing according to model 1.
  • Page 14 Coffee temperature Confirm selection Press the bean symbol MEDIUM corresponding to the required temperature HIGH Energy saving Confirm selection Press one of the bean symbols to enable energy saving Press the pre-ground symbol to disable energy saving LEVEL 1 Water hardness Confirm selection LEVEL 2 Press the symbol...
  • Page 15: Restore Factory Settings

    12.1 Restore factory settings Make sure the machine is in stand-by (off, but connected to the mains power supply). Press the buttons corresponding to drinks 1, 2 and hold for 5 seconds: all machine settings and drink quantities will be reset to the default factory values. The machine emits a long beep and all indicator lights blink to confirm the reset 13.
  • Page 16 Component Frequency Procedure Grounds container • Remove the drip tray, empty and clean. When the indicator lights up, the • Empty the grounds container and clean thoroughly grounds container must be emptied: the to remove all residues that may have collected on machine cannot now make coffee.
  • Page 17: Thorough Cleaning Of Milk Carafe

    14. THOROUGH CLEANING OF MILK CARAFE VERY IMPORTANT To ensure optimum results are obtained from the Lattecrema system over time, clean the milk carafe thoroughly on a regular basis. Clean the milk carafe as described below: 1. Press the release button (E4) and lift the lid (E2) (fig. 18); 2.
  • Page 18: Cleaning The Brewing Unit

    15. CLEANING THE BREWING UNIT 16. Once inserted, make sure the two coloured buttons have snapped out (fig. 37); To clean the removable brewing unit (at least once a month), 17. Close the brewing unit door; proceed as follows: 18. Put the water tank back. Important! The removable brewing unit is now clean and the machine is The brewing unit (A6) cannot be removed while the machine is on.
  • Page 19: Explanation Of Lights

    9. Press the button (which blinks rapidly) to start the rinse: the medium intensity Led blinks to indicate that step 2 of the descale cycle is in progress; 10. The machine will proceed automatically with rinsing of the coffee and hot water spouts; When the second step of the descaling cycle has been complet- ed, the low water level indicator (C2) will light up.
  • Page 20: Replace The Filter

    Indicator/Led Meaning Indicator/Led Meaning Drink and settings indicators The machine is ready for A selection has been made permanently alight use: select the desired drink using pre-ground coffee and relative options without putting the coffee in the relative funnel (A3) Replace the filter (see section “4.
  • Page 21: Troubleshooting

    Indicator/Led Meaning Indicator/Led Meaning The water circuit is empty. Descaling is required (“16. Descaling ” ) Deliver hot water by pressing the corresponding button Hot Water Descaling has been inter- rupted. Complete the cycle, restarting from the step indicated by the intensity •...
  • Page 22 Problem Cause Solution The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot water (Please note: the hot water function can be used). The internal circuits of the appliance have Before making coffee, warm the internal circuits cooled down because 2-3 minutes have by pressing and holding the button (B6)
  • Page 23: Technical Data

    Problem Cause Solution The milk presents large bubbles or splashes Milk is not cold enough, or is not semi- Use skimmed or semi-skimmed milk from the spout(E6) , or is under-frothed. skimmed or skimmed. straight from the refrigerator (tempera- ture about 5° C). If the result is still not as expected, try changing the brand of milk.
  • Page 25 De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com...

Table of Contents