Page 5
This Tool is suitable for "oil free"usage, this means that the compressed air does not need to have an oil lubrication. NOTE: the compressed air must be dry and clean, we advise the use of an air filter/regulator combination. Do not ignore safety precautions! Safety Do not modify this tool in any way, this can cause danger for the operator.
Page 6
Air under pressure can cause injuries, be aware of this. Never direct the exhaust air to yourself or anyone else. Do not use quick change couplings direct on the air inlet of the tool as these may release during operation. Assemble at least 50 cm air hose with a hose joint of shock resistant material.
Page 7
Using the tool: Before start using the tool, make sure that you are familiar with the workplace and surrounding area. Always obey the safety regulations for the work area you are working in. During operating the tool, the operator may be exposed to hazards as crushing, impacts, heat, vibration, cuts, abrasions, etc: Wear suitable gloves.
Page 8
Oil replacement should only be carried out by trained qualified specialists. For Yokota Impulse wrenches the advice is to replace the oil after 250.000 cycles on hard joint, one cycle is 0,5 – 1 second impulsing. On soft joints, longer impulsing time per cycle, the oil must be changed earlier.
Page 9
Warranty covers material or construction mistakes of the manufacturer, which are clearly definable. Replacement of parts or repair by an official Yokota/Red Rooster service workshop is free of charge, when the tool is covered by warranty. Freight or postage is for the account of the buyer. Damage attributable to a normal wear, overloading or incorrect use is excluded from warranty.
Need help?
Do you have a question about the YLTX50E and is the answer not in the manual?
Questions and answers