Chevrolet 2011 Corvette Navigation System Navigation Manual page 8

To set preset radio stations:
1. Press the power/volume knob to
turn the system on.
2. Press SRCE and select the
desired band (AM, FM1, FM2,
XM1, or XM2 (if equipped)).
3. Use SEEK arrows to tune to
the desired station.
4. Press and hold one of the six
preset screen buttons, at the
bottom of the screen, until a
beep is heard or the station
is displayed on the selected
preset button.
5. Repeat the steps for each
preset.
See Preset Station Menu under
information.
To set the time:
1. Press the power/volume knob to
turn the system on.
2. Press and hold the time display
in the upper right corner of any
screen.
3. Select the 12H or 24H screen
button to display the time in
standard or military time.
4. Press and hold the Hour and
Min. (minute) arrow buttons to
increase or to decrease the time.
5. Select the correct time zone
screen button.
6. Select the Daylight Saving Time
screen button, if necessary.
The radio uses the GPS satellite to
for more
set the time. The vehicle needs to
be in an open area to receive the
signal. See Clock under
information.
Before entering an Address,
Point of Interest, Home, or Preset
Destination, select the correct
region that contains the final
destination. The vehicle must
be stopped to do this operation.
To set the region:
1. If the radio is already on with
2. Press the power/volume knob to
3. Insert the DVD map disc.
for more
4. A Caution may appear.
a map disc inserted, skip to
Step 5.
turn the system on.
See Installing the Map DVD
under
more information.
Press Agree to proceed.
for