41.1 Command Interpreter Mode
The Command Interpreter (CI) is a part of the main system firmware. The CI provides much of
the same functionality as the SMT, while adding some low-level setup and diagnostic
functions. Enter the CI from the SMT by selecting menu 24.8. See the included disk or the
zyxel.com web site for more detailed information on CI commands. Enter 8 from Menu 24 —
System Maintenance. A list of valid commands can be found by typing help or ? at the
command prompt. Type "
Figure 258 Command Mode in Menu 24
Figure 259 Valid Commands
Copyright (c) 1994 - 2003 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys
wlan
lan
ras>
Chapter 41 System Maintenance
System Maintenance
This chapter leads you through SMT menus 24.8 to 24.10.
" to return to the SMT main menu when finished.
exit
Menu 24 - System Maintenance
1.
System Status
2.
System Information and Console Port Speed
3.
Log and Trace
4.
Diagnostic
5.
Backup Configuration
6.
Restore Configuration
7.
Upload Firmware
8.
Command Interpreter Mode
9.
Call Control
10. Time and Date Setting
11. Remote Management
Enter Menu Selection Number:
exit
ether
ip
ipsec
radius
8021x
Prestige 662HW Series User's Guide
C
H A P T E R
wan
bridge
4 1
412