Chapter 25 Remote Node Configuration; Remote Node Setup Overview; Remote Node Setup - ZyXEL Communications P-660H-61 User Manual

25.1 Remote Node Setup Overview

This section describes the protocol-independent parameters for a remote node. A remote node is
required for placing calls to a remote gateway. A remote node represents both the remote gateway and
the network behind it across a WAN connection. When you use menu 4 to set up Internet access, you
are configuring one of the remote nodes.
You first choose a remote node in Menu 11- Remote Node Setup. You can then edit that node's
profile in menu 11.1, as well as configure specific settings in three submenus: edit IP and bridge
options in menu 11.3; edit ATM options in menu 11.6; and edit filter sets in menu 11.5.

25.2 Remote Node Setup

This section describes the protocol-independent parameters for a remote node.
25.2.1 Remote Node Profile
To configure a remote node, follow these steps:
From the main menu, enter 11 to display Menu 11 - Remote Node Setup.
1.
When menu 11 appears, as shown in the following figure, type the number of the remote node that
2.
you want to configure.
Remote Node Configuration
Remote Node Configuration
This chapter covers remote node configuration.
Prestige 660H Series User's Guide
Chapter 25
25-1