Sealey MAC11 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT
IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE
WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
Read the manual before using this product. Thoroughly understand operating procedures, safety warnings and maintenance
9
requirements. Keep the manual in a convenient place for all users to see and use. Keep labels as per original.
The inflator only operates with a 12V electrical system.
9
Consult your vehicle's manual or a qualified mechanic for proper connection procedure.
9
After 30 minutes of continuous operation, allow the inflator to cool before restarting.
9
Damage can occur from continued overuse.
9
The inflator was permanently lubricated during assembly. DO NOT add oil or any other lubricant.
9
The inflator will become HOT after using for a long period of time. When used for a long period of time, the compressed air hose and
9
device may become noticeably warm.
Please use caution when touching the inflator in order to avoid burns. Allow the inflater to cool down sufficiently before storing.
9
Only inflate tyres to the manufacturer's recommended pressure. DO NOT over inflate as serious injury could occur.
9
Keep the inflator away from small children.
9
Clean with a damp cloth only. DO NOT use chemicals or soap.
9
DO NOT use the inflator for pumping any gas or liquid other than air.
8
The inflator is not designed for use as a source for breathable air.
9
The inflator is designed for use with car tyres. It is not designed for use with large tyres like tractor or truck tyres.
9
DO NOT use (or modify) the inflator for any other purpose than that for which it was designed.
8
Use extra caution when inflating small objects like bicycle tyres or sports balls.
9
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that
9
may occur. It must be understood by the operator that common sense and caution are applied when using this product.
Failure to heed these warnings may result in fatal personal injury and/or property damage.
9
2. INTRODUCTION
Suitable for inflating tyres on cars, vans, 4x4s, motorcycles and bicycles. Maximum pressure 120psi. Pressure units in psi, kPa, kg/cm²
and bar. Airflow 0.78cfm 22L/min with an inflation time 0-30psi in 263sec (175/70/R13). Analogue gauge with an LED worklight. Runtime:
30mins. Supplied with a 3m 12V plug, ball spike and inflatable adaptor.
3. SPECIFICATION
MODEL NO:
Hose Length
Maximum Current
Maximum Pressure
Nett Weight
Operating Voltage
Power Cord Length
Typical Inflation Time 0-30psi in 263sec (175/70/R13).
4. CONTENTS
© Jack Sealey Limited
TYRE INFLATOR WITH WORKLIGHT 12V
MODEL NO:
MAC11
360mm
10A
120psi
0.5kg
12V
3m
Original Language Version
MAC11
MAC11 Issue 1 12/12/24