Inel WM45DS-20/10 Installation And Operating Instructions

Installation and operating instructions for drive type: WM
DC drive with overload detection, built-in radio and battery recharged
by solar panel. The drive is designed for Zip Screen roller shutters.
• WM45DS20/10 -(N-20LERS)
Before installing the drive, connect it to the charger and
charge it until fully charged. The LED on the charger will
change from red to green.
1 Safety instructions
1.1 Basic guidelines
The drive shall be handed over in a condition for safe installation and
use, provided that all instructions in the operating manual are complied
with.
Alterations or modifications to the drive are not permitted. Warranty
repairs may only be carried out by the manufacturer. Only original spare
parts and accessories are to be used for post-warranty repairs. The
operational safety of the delivered drive is only guaranteed when used in
accordance with the manufacturer's specifications. The limit values
specified in the technical data may not be exceeded under any
circumstances.
1.2 Supplementary safety provisions
Important safety and accident prevention regulations must be observed
when installing, commissioning, maintaining the drive. The following
regulations require special attention:
1. fire regulations.
2 Accident prevention provisions.
1.3 General comments on hazards and safety measures
The specified notes are general guidelines when using INEL devices in
combination with other devices. These indications must be strictly
adhered to when installing and operating the equipment.
- Before installing the drive and setting the end positions, check the
fixing of all screw connections.
- The applicable safety and accident prevention regulations must be
observed.
- Wires and cables should be checked regularly for insulation damage
and conductor continuity.
- If the cables are found to be damaged, the damaged cables must be
replaced immediately after switching off the power supply.
1.4 Warning
- Don't let children play with the controls.
- Keep remote control devices out of the reach of children.
- Watch the blind moving and keep people away until it is fully open
or closed.
- Users of the roller shutter must be trained and instructed in how to
operate the roller shutter and in the dangers associated with its use.
People can be considered trained if the employer, administrator or
owner has allowed them to operate the roller shutter and has
instructed them on how to use it.
Instructions translated EN
Model:
WM45DS-20/10
2 Assembly instructions
2.1 Safety rules
▪ Installation of the drive must only be carried out by suitably
qualified persons.
▪ The weight of the roller shutter must not exceed the load capacity of
the drive as indicated in the selection table (table available at
www.inel.gda.pl).
▪ The proper way of laying the cable (loop facing downwards) further
protects the drive from possible water damage.
▪ Do not drill holes in the motor housing.
▪ Protect the engine from contact with any fluid.
▪ Avoid crushing, hitting the motor and protect the motor from falling.
2.2 Assembly of the drive
• Attach the mounting bracket (A) to the side of the roller shutter box,
connect the adapter (D) to the motor drive ring.
• Insert the special driver (E) (supplied with the motor) on the motor
shaft and secure it with the pin (F).
• Then slide the entire motor into the winding tube (G).
• Connect the winding tube and the driver with screws or rivets (H).
2.3 Electrical connections
Once the drive has been completed, mount the solar panel according to
the enclosed instructions and then connect the solar panel plug to the
drive socket. Attach the wires to the side of the box so that they do not
come into contact with moving parts.
Check the condition of the armouring, guides and roller shutter
box before starting / programming the drive.
The roller shutter box and the guides should be free of dirt and ensure
free movement of the roller shutter armour along its entire length. Dirt
from building materials or guides that are too tight can cause damage
to the drive and roller shutter, which is not covered by the guarantee.
Figure 1
Figure 2