Sony StorStation AITe200-UL Operating Instructions Manual page 18

18
Chapter 2 Preparation
Cleaning Request Mode
Automatic cleaning requests can be enabled by a DIP switch.
When switch 6 is ON, cleaning requests are enabled. When enabled, the
"CLEANING REQUEST" LED on the front panel lights after every 100
hours of operation.
When this LED lights, clean the drive with a head cleaning cartridge.
Note
To maintain the drive in optimum condition in environments affected by dust and other
contaminants, we recommend keeping cleaning requests enabled.
ON
OFF
1 2 3
Emulation Mode * (only for AITe130V-UL and AITe90V-UL)
To enable Emulation Mode, set position 1 - 4 Drive Mode switches to ON.
ON
OFF
1 2 3
*
Emulation Mode for the AITe130V-UL drive returns the following as the
Product Identification field of the Inquiry command.
SDX-520C
*
Emulation Mode for the AITe90V-UL drive returns the following as the
Product Identification field of the Inquiry command.
SDX-420C
Data Compression Control DIP switch
Data compression can be selected by DIP switches. Data compression is
enabled while position 7 [DC Control (1)] is ON. Control by host can be
disabled when position 8 [DC Control (2)] is ON.
4 5 6 7 8
4 5 6 7 8
1 Drive Mode
2 Drive Mode
3 Drive Mode
4 Drive Mode
5 Reserved
6 Periodic Cleaning Req (ON)
7 DC Control (1)
8 DC Control (2)
1 Drive Mode (ON)
2 Drive Mode (ON)
3 Drive Mode (ON)
4 Drive Mode (ON)
5 Reserved
6 Periodic Cleaning Req
7 DC Control (1)
8 DC Control (2)