Cabinet Installation - Electrolux E30EW75EPS - Icon Professional Series Installation Instructions Manual

Electric wall oven
Table of Contents

Advertisement

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS

4. Cabinet Installation

Heavy Weight Hazard
• Use 2 or more people to move and install wall oven.
• Failure to follow this instructions can result in injury or
damage to the unit.
The wall oven can tip when the door
is open. The mounting brackets supplied with the
wall oven must be attached to the cabinet and the
appliance to prevent tipping of the wall oven and
injury to persons.
Mounting Brackets Installation Instructions
1.Unpack the wall oven and find the 2 mounting
brackets and screws included in the literature package.
2.Install the mounting bracket in the cabinet as shown on
figure 4. Note: To prevent damage to cabinet, it is
recommended to drill 1/16" (0.16 cm) dia. pilot holes
before installing the mounting brackets.
Cutout Dimensions
28 1/2" (72.4 cm) Min.*
29" (73.7 cm) Max.*
Mounting
Brackets
23 1/4"
(59.1 cm)
Figure 4
3.Insert the unit into the cabinet opening. Slide unit inward
leaving 1 1/2" (3.8 cm) clearance between the oven and
front of cabinet (see Figure 5). Pull the armored cable
through the hole in the floor and toward the junction box
while moving the appliance inward.
4.Push the unit in and against the cabinet, then the oven
side bracket will clip in the one you just install on the side
of the cabinet opening (see figure 6).
To pull out the oven for servicing insert the tool supplied
with the appliance both side at the same time in the hole
located on the side frame and visible when the door is
opened. After inserting the tool pull the oven towards
you (see figure 7).
5.For typical under counter installation of an electric built-in
oven see Figure 8.
* Recommended
Cutout Width is 28½"
(72.4 cm)
28 1/4"
(71.8 cm) Min.
28 7/8"
(73.3 cm) Max.
Mounting
1
bracket installed
in cabinet
Oven
Bracket
Cabinet
Oven
Right Side
Tool
supplied
4
1 1/2" (3.8 cm)
clearance
between unit
Figure 5
Figure 6
2
3
Mounting
bracket released
Oven removed
from the cabinet
Hole where to insert
the tool
Figure 7

Advertisement

Table of Contents
loading

Table of Contents