Beghelli NYC-STX Installation Instructions

Read & Follow All Safety Instructions
When using electrical equipment, basic safety precautions should always be followed including:
1. Disconnect power before performing work on electrical equipment.
2. Do not use outdoors.
3. Do not mount near gas or electric heaters.
4. Do not let power cords touch hot surface.
5. Equipment should be mounted in locations and at heights where it will not be subjected to tampering.
6. The use of accessory equipment not recommended by Beghelli Inc., may cause an unsafe condition, and will void
the unit's warranty.
7. Do not use this equipment for other than its intended purpose.
8. Servicing of this equipment should be performed by a qualified service personnel.
9. DO NOT install in unstable, loose or breakable surfaces.
10. DO NOT let objects impact or exert force on the surface of the fixture.
IMPORTANT
When relamping, only use lamps specified in the exit. Using other lamp types may result in trans- former damage or
unsafe conditions. Battery (when applicable) in the unit may not be fully charged. After electricity is connected to the
unit, let the battery charge up for at least 24 hrs. The normal operation of the unit should then take effect.
WIRING DIAGRAMS
NOTE: Unused input lead must be properly insulated with wire nut or other approved method.
AC ONLY
INSTALLATION INSTRUCTIONS
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600
Page 1 of 2
NYC-STX
EMERGENCY
04/27/22