Freecom LTO 460I Manual page 33

Is the correct SCSI host bus adapter installed?
Description
The server already has a SCSI host bus
adapter but it is difficult to determine
what type it is.
The server may not have a SCSI host bus
adapter installed.
Do drivers need to be installed and, if so, which one?s
Description
It is unclear whether there is a need to
install drivers onto the system and more
help is required.
Testing after installation
Remember that the system recognizes devices during boot-up. If you swap or connect a
product when your system is running, you will need to reboot the system. Rebooting the system
will reset devices and will often resolve problems. It is good practice to reboot every time you
add a driver or install firmware.
Caution Never power off the drive while a cartridge is still loaded or during a firmware upgrade.
The computer does not reboot after installation
Possible reason
You have installed an additional SCSI
host bus adapter and its resources are
clashing with an existing adapter.
You have disconnected the power or SCSI
cable from the computer's boot disk
during the drive installation process.
Further information
You can check the SCSI configuration from the
boot-up screen or from the Windows Control
Panel.
If not, you will need to purchase one. See
"supported SCSI bus types" on page 7.
Further information
For detailed information specific to your system
check the software vendor's web site.
(Backup software that states support for Ultrium
Generation 2 tape drives also provides the
required drivers.)
Recommended action
Remove the new host bus adapter and check the
server documentation.
Check that the cables to all devices are firmly
connected.
31 31