Braun Satin Hair 3, HLH 310 Manual

Introduction

• Plug your appliance into an alternating current (~) outlet only and make sure that your household voltage corresponds to the voltage marked on your appliance.
• This appliance must never be used near water (e.g. a filled wash basin, bathtub or shower). Do not allow the appliance to become wet.
  
• Always unplug after use. Even switched off the appliance presents a hazard when near water.
• For additional protection, it is advisable to install a residual current device (RCD) with a rated residual operating current not exceeding 30 mA in the electrical circuit of your bathroom. Ask your installer for advice.
• Care should be taken not to block the inlet and outlet grill when the appliance is switched on. If either grill becomes blocked, the appliance will automatically cut out. After cooling for a few minutes, it will switch back on automatically.
• Do not wrap the mains cord around the appliance. Regularly check the mains cord for wear or damage. The mains cord of the appliance may only be replaced by an authorised Braun Service Centre. Unqualified repair work can lead to extreme hazards for the user.
• This appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities, unless they are given supervision by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach of children. Children should be supervised to ensure that they do not play with the appliance.
• Users of cardiac pacemakers (or defibrillators) should consult their doctor before using this hood. As a precaution, we recommend not using the hood, if the hood's motor unit may be placed close to the pacemaker (or defibrillator).

Description

1. Hood
2. Motor
3. Switch
4. Snap fastener
5. Cord winder
6. Cord

Before use

Separate the cord winder from the motor by simply sliding the motor upward (a).

Open out the hood fully, ensuring that there are no folds or creases in the plastic, particularly in the area where the hood is attached to the motor. Place hood on head before switching on. Also ensure that the motor is hanging correctly and is not twisted.

Lay the hood around your neck (b), then pull it over your head (c).

Unwind as much cord as you need and fix the cord by clamping it between the two ridges on the cord winder (d).

Then fasten the cord winder to the hood with the snap fastener (e).

Using the appliance

Turn the appliance on with the switch and select the temperature you find most comfortable (f).

Switch

= hot air

= warm air

= cool curl setting for long lasting curls

= off

When using the hood for the first time, do not switch to the high setting until the hood has been completely inflated. It is very important not to let hair cover the intake vents.

Cool curl setting

When your hair is dry, switch to the cool curl setting and let cool air blow on the hot curls for another 1-2 minutes. This will give them more body and bounce and makes your style last longer.

Storage, cleaning

After use and before each cleaning, always unplug the appliance. For easy storage, clip the motor and the cord winder back together and wrap the hood around both after the appliance has cooled off. Wipe the motor and the hood with a damp cloth only, never immerse into or hold under running water.