Welcome to AEG! Thank you for choosing our appliance. In our drive to be sustainable, we are reducing paper assets and provide full user manuals online. Access your full user manual at aeg.com/manuals Get usage advice, brochures, troubleshooting, service and repair information at aeg.com/support...
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. • Children between 3 and 8 years of age and persons with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised.
• The operating water pressure at the water entry point from the outlet connection must be between 0.5 bar (0.05 MPa) and 10 bar (1.0 MPa). • The ventilation opening in the base must not be covered by a carpet, mat, or any floor covering. •...
Centre to ensure which accessories can • When unpacking the appliance, It is be used. possible to see water flowing from the drain hose. This is due to the testing of the 2.2 Electrical connection appliance with the use of water in the factory.
Use • The ProSense technology detects the the delicate fragrance exclusively developed by AEG to add a pleasant laundry load size defining the programme feeling of "just-washed" garment to the duration in 30 seconds. The washing removing odours and wrinkles action.
Access your appliance details, documentation and articles on how to use the best features (User Manual also available at aeg.com/manuals ) • Get usage advice, troubleshooting, service and repair information (also available at aeg.com/ support ) • Buy accessories, Consumable and Original Spare parts for your appliance (also available at aeg.com/ shop ) ENGLISH...
4. TECHNICAL DATA Dimension Width/ Height/ Total depth 59.7 cm /84.7 cm /63.6 cm Electrical connection Voltage 230-240 V Overall power 2100 W Fuse 13 A Frequency 50 Hz Level of protection against ingress of solid particles and moisture ensured IPX4 by the protective cover, except where the low voltage equipment has no protection against moisture...
Page 9
5. Carefully put the appliance down on its rear side. 9. Remove the power supply cable and the 6. Put the front packaging element on the drain hose from the hose holders. floor under the appliance. It is possible to see water flowing Make sure not to damage the hoses.
We recommend that you keep the packaging and the transit bolts for any movement of the appliance. The appliance must be level and stable. 5.2 Installation on suspended flooring A correct adjustment of the appliance Suspended wooden floors are particularly level prevents the vibration, noise and susceptible to vibration.
5.5 The inlet hose WARNING! 1. Connect the water inlet hose to the back The inlet water shall not exceed 25 °C. of the appliance if needed. Usually, it is already installed at the factory. CAUTION! Make sure that there are no leaks from the couplings.
It is possible to connect the drain hose in different ways: min.600 mm max.1000 mm (*) Subject to change without notice. • Connect the drain hose to the spigot and tighten it with a clamp. • Position the hose directly to a built-in drain Make sure that the plastic guide cannot pipe in the room wall and tighten it with a move when the appliance drains and the...
required, also taking into account any other The power supply cable must be easily appliances may also be in use. accessible after installing the appliance. Connect the appliance to an earthed For any electrical work required to install this socket. appliance, contact our Authorised Service Centre.
Page 14
Spin touch button Temperature touch button 6.2 Display Door locked indicator. Washing phase indicator. It flashes during pre-wash and wash phase. Rinsing phase indicator. It flashes during rinse phase. Spinning and draining phase indicator. It flashes during spin and drain phase. Steam phase indicator.
The digital indicator can show: • Programme duration (e. g. The time shown when the programme is set could not correspond to effective duration and change after ProSense phase. • Maximum load. • Finish in time (e. g. • Cycle end ( ). •...
7.3 Introduction 7.6 PODS® Touch this button to activate or deactivate the PODS® option . The options/functions are not selectable When activated the relevant indicator is on. with all washing programmes. Check the Follow the Pods manufacturer's dosage and compatibility between options/functions storage recommendations.
The relevant indicator goes on in the display. • Press the On/Off button for a few seconds to activate or the deactivate the • Stains appliance. Select this option to add an anti-stain • Turning the programme dial in another phase to a programme in order to treat position.
The door stays locked. The drum turns . The appliance performs the only regularly to reduce creasing. You must draining phase of the selected washing drain the water to unlock the door. programme. Set this option for very Touch Start/Pause button : the delicate fabrics.
Extra Extra Time This option permanently set an extra rinse phase, if available with selected cy‐ Rinse Rinse Save cle, when is selected a new programme. Touch key combinations simultaneously for about 2 seconds until the indicator above the Extra Rinse push button and the corresponding icon on the display come on/go off Press the Extra Rinse button to deactivate the function on a single cycle execution without removing the permanent op‐...
Washing programmes Programme Programme description Cotton and mixed synthetic fabrics. Ideal to wash your daily load in a short time, for a better clothes care and good cleaning already at 30°C. MixLoad 69min The standard program duration has been developed on a laundry load of 5 kg.
Page 21
Programme Programme description Outdoor Do not use fabric softener and make sure that there is no softener residue in the detergent dispenser. Outdoor clothing, technical, sport fabrics, waterproof and breathable jackets, shell jackets with a removable fleece or inner insulation. The recommended laundry load is 2.0 kg.
Page 22
Programme temperature, maximum spin speed and maximum load Programme Default tempera‐ Reference spin speed Maximum load ture Spin speed range Temperature range 30 °C 1400 rpm 8.0 kg 60 °C - 30 °C 1400 rpm - 400 rpm MixLoad 69min 1400 rpm 10.0 kg 1400 rpm - 400 rpm...
Page 23
The Steam programmes do not remove particularly intense odour and do not perform any hygienic cycle. After the steam treatment the laundry can The fragrance is available on AEG web be humid. Hang items out for a few shop or by authorised dealer. minutes.
Programme Universal Liquid Univer‐ Liquid for col‐ Delicates Special oureds woollens powder 1) Wool ▲ ▲ 20min 3kg ▲ ▲ Outdoor ▲ ▲ Hygiene ▲ ▲ ▲ At temperature higher than 60 °C the use of powder detergent is recommended. ▲...
11.3 Filling the detergent and 1. Open the detergent dispenser. additives 2. If a prewash phase is set, put the powder detergent in compartment 3. For main wash, chose the proper compartment depending on the type of - Compartment for detergent pods (Max 2 pods). When using detergent tablets, make sure that the detergent: Pods®...
In case a selection is not possible an acoustic signal sounds. 11.5 Starting a programme Touch the Start/Pause button to start the programme. The related indicator stops flashing and stays The programme starts, the door is locked. The display shows the indicator c) Put the tablets in the compartment Make sure that the Pods®...
After touching the Start/Pause button, the ProSense starts the laundry load detection: The ProSense is not available with some 1. The appliance detects the load in the first programmes, such as Wool, programmes with short cycles and without washing 30 seconds: the indicator flashes, the phase.
11.10 Cancelling a running 11.12 End of the programme programme When the programme has finished, the appliance stops automatically. The acoustic 1. Press the On/Off button to cancel the signals operate (if they are active). programme and to deactivate the appliance.
• If you have set , the appliance only Press the On/Off button to activate the drains the water. appliance again. • After 5 minutes from the end of the The option indicator goes off, while washing programme. the indicator flashes and then goes off.
12.3 External cleaning fibers that fall off the clothes to be drained out with the water. Regularly examine the seal Clean the appliance with mild soap and warm and if necessary clean as described in the water only. Fully dry all the surfaces. following diagram.
small quantity of powder detergent or, if available, run the Machine Clean programme. If your appliance can be connected to Wi-Fi, the special programme Machine Clean is also downloadable through the APP. 4. Add a manually small quantity of powder detergent or a specific product into the empty drum, in order to rinse out any left residues.
CAUTION! Press the bottom cover as indicated in the picture. Make sure that it is closed properly. CLICK 6. Turn the dispenser up side down and open the bottom cover as indicated in the picture: first pull the side tabs outwards and then remove the bottom cover.
Page 34
Regularly check the drain pump filter and make sure that it is clean. Clean the drain pump filter if: • The appliance does not drain the water. • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump.
10. Clean the filter under the water tap. When you drain the water with the emergency drain procedure, you must activate the drain system again: a. Put 2 litres of water in the main wash compartment of the detergent dispenser. b.
12.11 Emergency drain If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain pump' paragraph. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate the drain system again: 1.
Page 37
13.1 Alarm Codes and Possible failures The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the tables). WARNING! Deactivate the appliance before carrying out any check. With some problems, the display shows an alarm code and the Start/ Pause button may flash continuously: If the appliance is overloaded, remove some items from the drum...
Page 38
• The programme was not finished properly or the appliance stopped too early. Switch the appliance off and on again. Internal fail. No communica‐ • If the alarm code appears again, contact the Authorised Service Centre. tion between electronic ele‐ ments of the appliance.
Problem Possible solution • The ProSense Technology is able to adjust the programme duration according The programme duration in‐ creases or decreases during to the type and the laundry load size. Refer to "The ProSense Technology load programme execution. detection" in "Daily Use" chapter. •...
5. Take out the laundry and then close the appliance door. 6. Close the filter flap. 14. CONSUMPTION VALUES 14.1 Introduction The QR code on the energy label supplied with the appliance provides a web link to the product information sheet. Keep the energy label for reference together with the user manual and all other documents provided with this appliance.
Page 42
sure that no laundry stays between the • The appliance starts. seal and the door. • At the and of the programme, remove the • Pour the detergent and other treatments in laundry. the proper compartment of the detergent • Push the On/Off button to turn the dispenser.
Programmes Load Product description 2.0 kg Cotton and synthetic items that need to de-wrinkle. Steam 2.0 kg Modern outdoor sporting garments. Outdoor 1.0 kg White cotton items. This programme removes more than 10.0 kg 99,99% of bacteria and viruses . It also ensure a proper re‐ Hygiene duction of allergens.
Need help?
Do you have a question about the LFSR74144UD and is the answer not in the manual?
Questions and answers