Zenith P42W22 Owner's Manual page 51

12. OSD select (Command:d)
G To select OSD (On Screen Display) on/off.
Transmission
[d][ ][Set ID][ ][Data][Cr]
Data 0 : OSD off
1 : OSD on
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : OSD off
1 : OSD on
* The remote control and Monitor front panel controls
(except main power) are not operable when the Monitor
is set up to be controlled by the PC computer.
13. Abnormal state (Command:a)
G To recognize an abnormal state.
Transmission
[a][ ][Set ID][ ][FF][Cr]
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : OK
1 : Fan alarm
2 : 5V down
3 : AC down
* This function is "read only".
14. PIP (Command:z)
G To control PIP (Picture-in-Picture). You can also control
PIP using the pip button on remote control or in the
Special menu.
Transmission
[z][ ][Set ID][ ][Data][Cr]
Data 0 : PIP off
1 : PIP (small)
2 : PIP (large)
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : PIP off
1 : PIP (small)
2 : PIP (large)
* PIP only works in the following resolutions:
RGB PC 640x480 (VGA) / 800x600(SVGA) / 1024x768
(XGA) (only in vertical frequency 60Hz),
Component 480p / 720p / 1080i.
15. PIP input select (Command:e)
G To select input source for sub picture in PIP mode.
You can also select source using input select button
on the remote control or in the Special menu.
Transmission
[e][ ][Set ID][ ][Data][Cr]
Data 0 : AV (VIDEO)
1 : COMPONENT
2 : S-AV (S-VIDEO)
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : AV (VIDEO)
1 : COMPONENT
2 : S-AV (S-VIDEO)
* COMPONENT source only works with 480i input signal.
51