Subscribe to Our Youtube Channel
Related Manuals for Vornado 753 OSC
Summary of Contents for Vornado 753 OSC
- Page 1 753 OSC WHOLE ROOM CIRCULATOR OWNER’S GUIDE READ AND SAVE THESE INSTRUCTIONS vornado.com...
- Page 2 We expect this If it is not, we product to be will make it perfect. right. vornado.com 800-234-0604 help@vornado.com English...
-
Page 3: Table Of Contents
CONTENTS Important Safety Instructions ............. 4 Remote Control ................11 Features ....................8 Cleaning .................... 12 Getting Started .................. 9 Troubleshooting ................14 How to Use ..................10 Warranty .................... 16 English... -
Page 4: Important Safety Instructions
Do not use this product outdoors or expose it to the product, to any future owner. See www.vornado.com to view, weather or elements. download and print the most current version of these instructions. - Page 5 For information about available products and parts replacement, visit vornado.com/support or contact - Call a local poison control center for treatment information. If you Vornado Consumer Service by phone (1-800-234-0604) or email think batteries might have been swallowed or placed inside any part (consumerservice@vornado.com).
- Page 6 2. Grasp the plug (not the cord) and disconnect from the outlet. 3. Risk of Fire. Replace fuse only with 2.5 Amp, 125 Volt fuse as approved by Vornado Consumer Service. For an authorized replacement fuse, please contact Vornado Consumer Service.
- Page 7 - Connect the product into an outlet on a circuit different from that to which the receiver is connected. - Contact Vornado Consumer Service or dealer or an experienced radio/TV technician for help. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to...
-
Page 8: Features
FEATURES Save energy by maximizing the performance of heating and cooling systems. When you use a Vornado Air Circulator, you will not have to set your summertime thermostat as low or your wintertime thermostat as high. CARRY HANDLE WITH PIVOTING HEAD... -
Page 9: Getting Started
GETTING STARTED SCENT-READY PAD This pad is unscented. To add your favorite essential oil to the pad, please follow the below instructions: 1. Remove the Scent-Ready Pad Cap. 2. Add a few drops of essential oil to the Scent-Ready Pad. NOTE: Use caution when adding essential oil. -
Page 10: How To Use
HOW TO USE CONTROLS Power On/Off 1. Press to Power On. 2. Select desired Speed Setting by pressing button. Fan Speed (cycle 1-3) 3. Press to turn Oscillation on and off. 4. Press Oscillation to activate Timer. To adjust the Timer, press to cycle from 1 to 8 hours. -
Page 11: Remote Control
REMOTE CONTROL REMOTE FUNCTIONS BATTERY INSTALLATION & REPLACEMENT 1. Press to Power On. The remote control for this fan operates with two (2) AAA batteries (included). To install the batteries, gently press down and slide the 2. Select desired Speed Setting by pressing +/– Side Button. battery door downward, following the direction indicated by the tex- 3. -
Page 12: Cleaning
CLEANING GRILLE REMOVAL Screwdriver required. WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing grille. 1. Remove the 3 screws located in between the ribs of the inlet grille at roughly 10, 2, Front Grille Clip Front Grille Clip and 6 o’clock positions. -
Page 13: Blade Removal
CLEANING BLADE REMOVAL Pliers recommended. WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing blade. 1. First, remove the nut from the shaft by turning the nut clockwise to loosen. Pull the blade straight out from the shaft. -
Page 14: Troubleshooting
Under certain conditions, it is possible for a reset GFCI (Ground Fault Circuit Interrupter) outlet to trip when the user is changing speeds on a Vornado circulator. In this event, change to an outlet that is not connected to a GFCI device. - Page 15 PROBLEM POSSIBLE CAUSE AND SOLUTION Remote control is not The batteries are dead. Replace with two (2) new AAA batteries. Refer to Remote Control section. working. The remote requires a line-of-sight path to allow for the signal to be received by the unit. Position the unit so the receiver lens (located inside the display panel) is visible from the remote control.
-
Page 16: Warranty
This warranty After receiving the RA form, ship your Product to: Vornado Air LLC Attn: Warranty & Repair gives you specific legal rights, and you may have other rights that vary from state to state. - Page 17 Vornado Air, LLC 415 East 13th Street, Andover, Kansas 67002 800.234.0604 | vornado.com CL3-1111 R-, V00...
Need help?
Do you have a question about the 753 OSC and is the answer not in the manual?
Questions and answers