For Windows 95, 98, And Me; For Windows 2000 - Uniden evolo WNR2004 Owner's Manual

FOR WINDOWS 95, 98, AND ME

1. Click on Start, Settings, Control Panel. Double click on
Network.
2. In "The following network components are installed"
box, select the TCP/IP associated with your network adapter.
(If you have only one network adapter installed, you will only
see one TCP/IP listed.)
Properties button.
3. In the "TCP/IP Properties" window, select the "IP Address"
tab. If the "Obtain an IP address automatically" is
checked, this computer is ready to communicate with the
WNR2004. If it is not, proceed to step 4.
4. If there is an IP address listed, WRITE DOWN this IP
address on the memo page of this manual (page 115).
5. Select the DNS configuration tab. If there is an IP address
listed on this tab, WRITE DOWN this IP address on the
memo page of this manual (page 115).
NOTE: After you've configured your PC to communicate
with the WNR2004, you might need to enter these IP
addresses into the router in order to share your
internet access through your Cable or DSL modem.
6. Select Obtain an IP address automatically.
7. Click the OK button in the "TCP/IP Properties" window, and
click OK in the "Network" window.
8. Restart the computer if asked.
Repeat for each PC on your network. When all of your PCs are
configured, continue to Step 3: Basic Router Configuration on
page 21.
17
Highlight it and click the

FOR WINDOWS 2000

1. Click on Start, Settings, Control Panel. Double click on
Network and Dial-up Connections.
2. Right click on the Local Area Connection that is associated
with the network adapter you are using and select the
Properties option.
3. In the "Components checked are used by this
connection" box, highlight Internet Protocol (TCP/IP), and
click the "Properties" button. If the "Obtain an IP address
automatically" is checked, this computer is ready to
communicate with the WNR2004. If it is not, proceed to
step 4.
4. If there are any IP addresses listed on this screen, WRITE
DOWN these IP addresses on the memo page of this
manual (page 115). There may be an IP address listed
under Use the Following IP Address and one under Use
the Following DNS Server Addresses. Be sure to make a
note of BOTH IP addresses.
NOTE: After you've configured your PC to communicate
with the WNR2004, you might need to enter these IP
addresses into the router in order to share your
Internet access through your Cable or DSL modem.
5. Select Obtain an IP address automatically.
6. Click the OK button in the Internet Protocol (TCP/IP)
Properties window, and click the OK button in the Local
Area Connection Properties window.
7. Restart the computer if asked.
Repeat for each PC on your network. When all of your PCs are
configured, continue to Step 3: Basic Router Configuration on
page 21.
18