Uniden evolo WNR2004 Owner's Manual page 36

from. Be sure to enter the four separate parts of the IP
address into the four separate boxes in the field.
6. In the Source End IP Address field, enter the last IP
address of the range of you want to filter packets from. If
you want to filter from a single IP address, enter the same IP
address as the Start IP Address. Be sure to enter the four
separate parts of the IP address into the four separate boxes
in the field.
NOTE: IP addresses entered in these fields are consecutive.
If you need to filter packets from non-consecutive IP
addresses, enter the IP addresses as two or more
different ranges.
7. In the Source Start Port field, enter the first port of the
range you want to filter packets from. (See Table 2 on page
51 for a few of the most commonly needed well-known
ports.)
8. In the Source End Port field, enter the last port of the range
you want to filter packets from. To filter packets from a
single port, enter the same port number in the Start and End
fields.
NOTE: Port ranges are consecutive. If you need to filter
packets from non-consecutive ports, enter the ports
addresses as two or more different ranges.
9. If you want to forward packets, in the Destination Start IP
Address field, enter the first IP address of the range of
addresses you want to send packets to. Be sure to enter
the four separate parts of the IP address into the four
separate boxes in the field.
10. In the Destination End IP Address field, enter the last IP
address of the range of you want to send packets to. If you
want to send packets to a single IP address, enter the same
71
IP address as the Start IP Address. Be sure to enter the
four separate parts of the IP address into the four separate
boxes in the field.
NOTE: IP addresses entered in these fields are consecutive.
If you need to send packets to non-consecutive IP
addresses, enter the IP addresses as two or more
different ranges.
11. In the Destination Start Port field, enter the first port of the
range you want to send packets to. (See Table 2 on page
51 for a few of the most commonly needed well-known
ports.)
12. In the Destination End Port field, enter the last port of the
range you want to send packets to. To send packets to a
single port, enter the same port number in the Start and End
fields.
NOTE: Port ranges are consecutive. If you need to send
packets to non-consecutive ports, enter the ports
addresses as two or more different ranges.
13. In the Protocol field, select TCP, UDP, TCP/UDP, or ICMP
according to the needs of your network.
14. Under the Interface field, select whether the destination IP
address is attached to the router's WAN port or one of the
LAN ports.
15. Under the Action field, select Forward to send the packets
to a destination IP address or select Block to restrict the
data packets from entering your network.
NOTE: If you select Forward, you must enter a destination
IP address.
16. Click Apply. This will take you back to the Packet Filtering
screen (see Figure 30 on page 69).
72