Trouble Shooting; Power Led Does Not Turn On; Test Led Stays On; Test Led Does Not Come On - Uniden evolo WNR2004 Owner's Manual

MANUAL KEY ENTRY
To manually enter the WEP keys, perform the following steps:
1. Select either 64-bit or 128-bit WEP encryption from the
pull-down menu.
2. When WEP 64-bit is selected, type 5 alpha characters
in the range of "A-Z" (e.g. MyKey) in the WEP Key 1
entry field. Alternatively, you may enter 10 digit
hexadecimal values in the range of "A-F" and "0-9".
You can also enter WEP keys in the Key 2, Key 3 and
Key 4 if you wish. Select the active WEP key set (1, 2,
3, or 4) for 64-bit encryption.
128- bit WEP encryption consists of 26 hexadecimal
characters and 13 alpha characters. Verify that you are
using the same active key for all clients on your wireless
network.
Click Apply. Remember that changes do not take
3.
effect until after you Reboot your WNR2004 Wireless
AP/Router. See Rebooting the Router on page 77.
89

Trouble Shooting

This section provides a brief troubleshooting guide for common
problems. If this guide does not solve your problem, see our
support website at www.uniden.com/productsupport.cfm or
contact customer support at 1 (800) 775-9060

POWER LED DOES NOT TURN ON

1. Make sure the power adapter is properly connected to your
router.
2. Check that you are using the 7.5V DC power adapter
supplied with the router.
3. Test the outlet the router is connected to, or move the power
connection to another outlet.
If all connections are fine but the router still does not power on,
contact technical support.

TEST LED STAYS ON

When you reboot the router, the Test LED comes on while the
router undergoes its power-on-self test. The LED should go out
when the router completes its self-test. If the Test LED does not
go out, cycle the power on the router. If the Test LED still does
not go out, contact technical support.

TEST LED DOES NOT COME ON

When you reboot the router, the Test LED comes on while the
router undergoes its power-on-self test. The LED should go out
when the router completes its self-test. If the Test LED does not
come on during a reboot, cycle the power on the router. If the
Test LED still does not come on, contact technical support.
90