Wpa Security Settings; Wireless Lan Plugins - Nokia 002J3H6 User Manual

identifies your device to the WLAN to which you
connect.

WPA security settings

Select WPA/WPA2
Select WLAN security settings
WPA/WPA2 — Select
•
Authentication Protocol) or
secret key used for device identification).
EAP plug-in settings
•
EAP, select which EAP plug-ins defined in your
device to use with the access point.
Pre-shared key
•
shared key, enter the shared private key that
identifies your device to the WLAN to which you
connect.
WPA2 only mode
•
(Advanced Encryption Standard) encryption, select
Off. To allow AES only, select

Wireless LAN plugins

Select Menu Tools
>
Access points.
The EAP (extensible authentication protocol) plug-ins
are used in wireless networks to authenticate wireless
devices and authentication servers, and the different
EAP plug-ins make possible the use of various EAP
methods (network service).
You can view the EAP plug-ins currently installed in
124
your device (network service).
as the WLAN security mode.
and from the following:
EAP (Extensible
Pre-shared key
— If you select WPA/WPA2
— If you select WPA/WPA2
— To allow both TKIP and AES
On
Settings Connection
> >
EAP plug-ins
1. To define the EAP plug-in settings, select
New access point
uses WLAN as a data bearer.
2. Select 802.1x
3. Select WLAN security settings
EAP EAP plug-in
>
Use EAP plug-ins
(a
To use an EAP plug-in when you connect to a WLAN
>
using the access point, select the desired plug-in and
Options > Enable. The EAP plug-ins enabled for use
with this access point have a check mark next to them.
Pre-
>
To not use a plug-in, select
To edit the EAP plug-in settings, select
Edit.
To change the priority of the EAP plug-in settings, select
Options Raise priority
>
in before other plug-ins when connecting to the
network with the access point, or
priority to use this plug-in for network authentication
after attempting to use other plug-ins.
See the device help for more information on EAP
>
plugins.
Session initiation protocol
(SIP) settings
Select Menu
>
SIP settings.
and define an access point that
or WPA/WPA2 as the security mode.
WPA/WPA2
>
settings.
Options > Disable.
Options
to attempt to use the plug-
Options
Tools Settings Connection
> >
Options
>
>
>
Lower
>
>