Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Shark MATRIX PLUX RV2620WAUK
Summary of Contents for Shark MATRIX PLUX RV2620WAUK
- Page 1 Robot Vacuum RV2620WAUK OWNER’S GUIDE...
-
Page 2: Important Safety Instructions
If the charging cable plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contain explosive or toxic fumes or 38. Use ONLY the Shark® charging dock contact a qualified electrician. DO NOT force into outlet or try to modify to fit. - Page 3 GETTING TO KNOW YOUR SHARK MATRIX PLUS 2-IN-1 ROBOT GETTING TO KNOW YOUR SHARK MATRIX PLUS 2-IN-1 ROBOT ™ ™ ROBOT DUST BIN Charge Indicator Lights VAC & MOP 2-in-1 Dust Bin Wi-Fi Indicator Light Error Indicator Light Filter Front Bumper...
-
Page 4: Installing The Side Brush
SELF-EMPTY BASE ROBOT BATTERY INDICATOR LIGHTS In Use Full Partial Charge Charge Charge (White) (White) (Red) While Charging (White) 0.3m No Charge or Off 0.3m The white charge indicator lights show how much battery power is remaining. 0.6m While the robot is charging, both white LED lights will flash. -
Page 5: Buttons And Indicator Lights
CHARGING BUTTONS AND INDICATOR LIGHTS IMPORTANT: The Shark Matrix™ Plus 2-In-1 Robot has a pre-installed rechargeable battery. Charge the battery completely before first use. It may take up to 6 hours to fully charge. CLEAN BUTTON Press to begin a cleaning session and press again to pause the cleaning session. - Page 6 PREP YOUR HOME USING THE SHARK MATRIX PLUS 2-IN-1 ROBOT ™ AI LASER NAVIGATION™ Your robot uses an array of sensors to navigate around walls, furniture legs, and other obstacles while it cleans. To prevent the robot from entering areas you don't want it to, set up no-go zones in the app. For best results, prepare your home as indicated below, and schedule a daily cleaning to ensure all floor areas are regularly maintained.
- Page 7 VAC & MOP 2-IN-1 CLEANING MODE VACUUM-ONLY CLEANING MODES Dining Room Dining Room Kitchen Kitchen Living Room Living Room Spot Clean Matrix Mop Single-Room Matrix Clean Whole-Home Cleaning Whole-Home Cleaning To clean a specific 1.5m by 1.5m spot, place the robot in Once the robot has a created map, you can select a To activate a whole-home clean when in vacuum-only To start a whole-home Vac &...
- Page 8 USING THE SHARK MATRIX PLUS 2-IN-1 ROBOT USING THE SHARK MATRIX PLUS 2-IN-1 ROBOT ™ ™ VAC & MOP 2-IN-1 SETUP VAC & MOP 2-IN-1 SETUP NOTE: Before it can mop, the robot MUST complete an Explore Run with the pad plate removed.
-
Page 9: Maintenance
MAINTENANCE MAINTENANCE EMPTYING THE SELF-EMPTY BASE DUST BIN To turn the robot power off, take it off the Self-Empty Base and press the DOCK button on the robot for 5-7 seconds. CAUTION: Turn off power before performing any maintenance. Remove the vac & mop 2-in-1 dust bin before any maintenance. - Page 10 MAINTENANCE MAINTENANCE CLEANING AND REPLACING THE ROBOT'S FILTERS CLEANING AND REPLACING THE SELF-EMPTY BASE FILTERS Regularly clean the filters to keep your vacuum's suction power optimal. Replace filters every 6-12 For optimal suction power, please clean and reinsert the Self-Empty Dust Bin filter after each use. months or as needed.
- Page 11 MAINTENANCE MAINTENANCE CLEANING THE SELF-CLEANING BRUSHROLL CLEANING THE VAC & MOP 2-IN-1 DUST BIN AND MOPPING PAD The Self-Cleaning Brushroll actively removes hair wrap while your robot cleans. If some debris remains wrapped around the brushroll, continue to run the robot to give the brushroll time to clean itself. If some hair wrap or debris remains after continued cleaning, carefully remove it from the brushroll.
- Page 12 “Link.” 3. Sign in to your SharkClean account. This is the same account you used when setting up your Shark® robot in the SharkClean app. To send your robot in to action, use the voice command, “Google, tell Shark®...
- Page 13 It is normal for your robot to temporarily lose connectivity when it goes under furniture or moves far from your router. Your Shark® robot will automatically reconnect to Wi-Fi. If the robot does not reconnect, power it off, wait 10 seconds, power the robot back on, and place it back on the base. Take the robot off the base and press REPLACEMENT PARTS: ROBOT and hold the DOCK button on the robot for 5-7 seconds to turn off power.
-
Page 14: Error Codes
ERROR CODES END-USER LICENSE AGREEMENT FOR SHARKNINJA SOFTWARE If any error lights are illuminated or flashing on your Shark Matrix™ Plus 2-In-1 Robot, see the IMPORTANT: PLEASE READ THE TERMS AND CONDITIONS OF THIS LICENCE AGREEMENT CAREFULLY BEFORE COMMENCING USE OF THIS PRODUCT error code chart below: This End-User License Agreement (“EULA”) is a legal agreement between you and SharkNinja Operating... -
Page 15: Manufacturer's Guarantee
If you further agree to receive communications from us, you can also 7. OUR RESPONSIBILITY FOR LOSS AND DAMAGE CONSUMERS SUFFER. receive tips and advice on how to get the best out of your Shark appliance and hear the latest news about new Shark technology and launches. - Page 16 MANUFACTURER'S GUARANTEE NOTES SharkNinja Europe Ltd, 1st/2nd Floor Building 3150, Thorpe Park, Century Way, Leeds, England, LS15 8ZB SharkNinja Germany GmbH, Rotfeder-Ring 9, 60327 Frankfurt am Main, Germany sharkclean.co.uk Illustrations may differ from actual product. We are constantly striving to improve our products; therefore the specifications contained herein are subject to change without notice.
-
Page 17: Register Your Purchase
Expected runtime: 60 minutes Expected charging time: 6 hours PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE. This Owner's Guide is designed to help you keep your Shark Matrix Plus 2-in-1 robot running at peak performance. SharkNinja Europe Ltd, 1st/2nd Floor Building 3150,...
Need help?
Do you have a question about the MATRIX PLUX RV2620WAUK and is the answer not in the manual?
Questions and answers