Welcome to Electrolux! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.electrolux.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. INSTALLATION....................5 4. PRODUCT DESCRIPTION................7 5.
• Children of less than 3 years of age should be kept away from the appliance unless continuously supervised. • Children should be supervised to ensure that they do not play with the appliance. • Keep detergents away from children. •...
• If the appliance has ventilation openings in the base, they must not be covered e.g. by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused.
parts related to door assemblies, printed WARNING! circuit boards, electronic displays, pressure switches, thermostats and Dangerous voltage. sensors, software and firmware including reset software. The following spare parts 2.4 Use are available for at least 10 years after the • Do not put flammable products or items model has been discontinued: door hinge that are wet with flammable products in, and seals, other seals, spray arms, drain...
Page 6
Authorized Service Centre to replace it with the new one. www.youtube.com/electrolux www.youtube.com/aeg How to install your AEG/Electrolux 60 cm Sliding Door Dishwasher 3.2 Safety caps If the furniture panel is not installed, open the appliance door carefully to avoid the risk of injury.
4. PRODUCT DESCRIPTION Upper spray arm Cutlery basket Lower spray arm Lower basket Filters Upper basket Rating plate Salt container The graphic is a general overview. For Air vent more details, refer to other chapters or documents provided with the appliance. Rinse aid dispenser Detergent dispenser 5.
5.1 Indicators Indicator Description Drying phase indicator. It is on when you select a programme with the drying phase. It flash‐ es when the drying phase operates. Salt indicator. It is on when the salt container needs refilling. It is always off while the pro‐ gramme operates.
6.1 Consumption values Water Energy Duration Programme 1)2) (kWh) (min) 0.936 11.6 1.170 11.7 1.034 0.540 0.013 The pressure and the temperature of the water, the variations of the mains supply, the options, the quantity of dishes and the degree of soil can change the values. The values for programmes other than ECO are indicative only.
The water softener should be adjusted flashes and the indicators according to the hardness of the water in your area. Your local water authority can advise you on the hardness of the water in your 7.2 The water softener area. Set the right level of the water softener The water softener removes minerals from to assure good washing results.
The intermittent flashing of the indicator Water softener level Amount of water (l) shows the current setting: e.g. 5 flashes + pause + 5 flashes = level 5. 2. Press the programme button repeatedly to change the setting. Each pressing of the programme button increases the level number.
There is also an acoustic signal that sounds CAUTION! when the programme is completed. By default this acoustic signal is deactivated but Do not try to close the appliance door it is possible to activate it. within 2 minutes after automatic opening. This can cause damage to the appliance.
After starting the programme, the appliance CAUTION! recharges the resin in the water softener for up to 5 minutes. The washing phase starts Water and salt can come out of the salt only after this procedure is complete. The container when you fill it. To prevent procedure is repeated periodically.
9. DAILY USE 1. Open the water tap. 2. Press the on/off button to activate the appliance. For information about the detergent Make sure that the appliance is in programme dosage, refer to the manufacturer's selection mode. instructions on the packaging of the •...
duration. After closing the door, the appliance Cancelling the programme continues from the point of interruption. Press the on/off button for 3 seconds until the appliance is in programme selection mode. Make sure that there is detergent in the If the door is opened for more than 30 detergent dispenser before you start a new seconds during the drying phase, the programme.
– Make sure that the current level of the 3. Start the shortest programme with a water softener agrees with the rinsing phase. Do not add detergent and hardness of the water supply. do put dishes in the baskets. – Follow the instructions in the chapter 4.
10.6 Unloading the baskets 1. Let the tableware cool down before you After the programme is completed, water remove it from the appliance. Hot items can still remain on the inside surfaces of can be easily damaged. the appliance. 2. First remove items from the lower basket, then from the upper basket.
7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. CAUTION! An incorrect position of the filters can cause bad washing results and damage...
3. To install the spray arm back, press it downwards. 2. Wash the spray arm under running water. Use a thin pointed tool, e.g. a toothpick, to remove particles of soil from the holes. 11.6 Cleaning the upper spray arm Do not remove the upper spray arm.
Page 20
Problem and alarm code Possible cause and solution The programme does not start. • Make sure that the appliance door is closed. • If the delay start is set, cancel the setting or wait for the end of the countdown. •...
Page 21
Problem and alarm code Possible cause and solution Technical malfunction of the appliance. • Switch the appliance off and on. • The indicator flashes 12 times intermit‐ tently. • Acoustic signal sounds 12 times intermittent‐ The level of water inside the appliance is too •...
Page 22
WARNING! We do not recommend using the appliance until the problem has been completely fixed. Unplug the appliance and do not plug it in again until you are certain that it operates correctly. 12.1 The dishwashing and drying results are not satisfactory Problem Possible cause and solution Poor washing results.
Problem Possible cause and solution There are residues of detergent in the • The detergent tablet got stuck in the dispenser and was not washed dispenser at the end of the pro‐ away by water. gramme. • Water cannot wash away the detergent from the dispenser. Make sure that the spray arm is not blocked or clogged.
It is possible to find information related to the rating plate of the appliance. Refer to the performance of the product in the EU EPREL chapter "Product description". database using the link https:// For more detailed information about the eprel.ec.europa.eu and the model name and energy label, visit www.theenergylabel.eu.
Need help?
Do you have a question about the KEAF7215L and is the answer not in the manual?
Questions and answers