Maintenance; Replacing Drive Belt - Delta 46-745 Instruction Manual

A
6. Use an outboard tool rest (B) Fig. 69 for all outboard turnings.
7. Fig. 70 illustrates the correct method for outboard
A
B

REPLACING DRIVE BELT

1. Use the supplied Allen wrench (A) Fig. 71 to loosen the set screw in the handwheel (B) Fig. 71. Engage spindle
lock (C) and rotate handwheel clockwise to remove.
2. Use a 7/32" Allen wrench (A) Fig. 72 to remove screw (B) Fig. 72 from locking handle. Remove locking handle (C).
C
B
3. While holding the motor (A) Fig. 73 with one hand, use a 9/16" wrench (B) to remove nut (C). Lift motor (A) and
remove belt from motor pulley.
4. Pull motor (A) Fig. 73 out, bring it around the back of the lathe, and place it on the lathe bed (Fig. 74)
B
Fig. 69

MAINTENANCE

Fig. 71
A
Fig. 73
turnings.
B
C
A
21
Fig. 70
C
Fig. 72
Fig. 74