Polygroup TG70P4474D01 Manual

Carefully review all instructions. If you have a problem, call or email the
manufacturer. Tree Warranty is Valid through December 31, 2026.
Email: warranty@polygroup.com
Phone: (888) 919-0070
WARNING:
To reduce the risk of fire and electric shock:
a) Use only the power supply that was provided with this product.Using a different adapter will damage the lights and may cause
fire, or electrical shock hazards.
b) Do not add any light strings or other power supplies other than what has been provided with this product.
c) Do not mount or support strings in a manner that can cut or damage wire insulation.
d) Do not use near candles, heaters, or other similar sources of heat.
e) Do not use candles on tree.
f ) Do not use near tubs, sinks, or other wet areas.
g) Artificial trees are made from small fibers that may pose a choking hazard if detached from
the branches.Use care around children and pets.
h) The controller and remote controller (if included) can only be used with this product.
TREE ASSEMBLY INSTRUCTIONS
Congratulations on purchasing your new tree from
Carefully follow the instructions below on how to quickly and easily set up your new tree.
Ensure all packaging is removed before assembly and use. Keep tree's light sets unplugged from power before beginning assembly.
Ensure final assembly is upright and stable.
1. Before you start to assemble your tree, choose an appropriate location near a wall outlet.
2. Assemble the tree stand and place on a level surface. (See Fig. A)
Fig. A - Tree Stand Assembly
Fig. B - Tree and Light Assembly
3. Each tree section is numbered with a tag. Please identify all sections before assembling.
4. Assemble the tree from the bottom to the top. Start with the bottom section and remove protective cap before inserting into the
assembled stand. Make sure the pole is firmly inserted and secured into the stand.
Note: Do not step on the tree stand legs during the setup. This may deform the tree stand and may result in an unbalanced tree.
5. Continue by inserting the upper tree section(s) to the lower section(s) until inserting the tree top.
6. Allow branches to fall into place or gently pull up and out. When adjusting branches, be sure that all wires are free of branch hinges.
7. Connect the plug(s) securely to the extension cord(s) as per the color labels indicated in (See Fig. B) and insert the green label adapter
into the wall outlet. Your entire tree should now be lit. If some bulbs do not light or flicker, search for any loose plugs and/or broken,
loose or missing bulbs. Replace bulbs promptly in order to maintain the performance and life expectancy of your pre-lit tree.
Polygroup®!
Tree top
Section 2
Section 1
Page 1 of 2
Unfold the legs and lay the
stand in a flat area. Then slide
the locking disc downward and
snap into place.
Electrical Rating For The Tree
(For Indoor Use Only)
Input: AC 120V, 60Hz, 0.16A
Output: DC 29V, 0.28A
Controller: 0.28A
Insert Red Label
Plugs Into Red
Labeled Extension Cord
Foot Pedal
Insert Green
Light Controller on/off switch
Label Extension
Cord into Adapter
B19 7FT PRE-LIT FLOCKED
HARDWICKE SPRUCE TREE
TG70P4474D01
MODEL # :
SKU # : 124404889
Adapter
To Be Plugged
Into Wall
Outlet