Optional Parts; "How-To" Install The Wheel; Tool Preparation; Installation Procedures - Yamaha EF12000DE - Premium Generator Owner's Manual

OPTIONAL PARTS

"HOW-TO" INSTALL THE WHEEL

(
1) Checking of supplied accessories

(2) Tool preparation

Hoist or square bar (100 mm (3.94 in) by 100 mm (3.94 in), length : 700 mm (27.56 in))
Plier
Spanner or socket wrench (12 mm (0.472 in)), 2 units

(3) Installation procedures

(a) Raise the generator by about 100 mm (3.94 in), with hoist or with square bar put under
the bottom panel.
(b) Attach wheel mounting parts
wheel shaft .
Then check that wheel
cated, assemble them together using grease. (4 locations / 2 pieces)
(c) Bend the tip of
(d) Attach the assembled shaft to the foundation plate of the engine, using
(e) Attach the other shaft to the foundation plate of the generating unit, using
( is not used.)
The tightening torque of bolts should be
REMOTE CONTROL UNIT
When the remote control unit is connected, the engine will not start unless both starter
switch on the control panel and the engine switch on the remote control unit are switched
on.
, ,stopper
is rotated smoothly. If moving turns out to be too compli-
according to the shape of wheel shaft
, using clamp
20 to 25 Nm (
2.0 to 2.5 kg-m).
WARNING
If you provide the generator with wheels,
always be sure to place the generator on
a level surface, locking the wheel with
the stopper and /or chocking the wheels.
38
- -
and wheel
as possible.
, , and
and
, to
.
.