Intex PureSpa SC-WF10 Owner's Manual page 11

Defl ation
For Spa Tub Wall:
1. Unscrew the cap to reveal the stem, push the stem in
and turn 90 degree right to secure it in the down position
(see drawing 9).
2. Once the defl ation is completed, push the stem in and
turn 90 degree left to return it to the infl ation position.
3. Replace the cap back.
NOTE: To defl ate the spa tub for storage, see "STORAGE"
section.
For Cover Air Bladder:
1. Pull valve cap out and squeeze the valve at its base until defl ated.
2. Close and recess the valve back.
The spa tub infl ation/defl ation valve incorporates an "air pressure release" function that automatically
releases excess air when the spa tub internal pressure is between 1.5 - 2.5 psi (0.103 - 0.172 bar).
Air pressure release valve.
Colder temperatures at night
cause the spa to seem less
infl ated.
S AVE THESE INSTRUCTIONS
(351PO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 11/30/2021
SET UP (continued)
IMPORTANT
Infl ation of spa in the morning.
Air expands in the midday
heat and correct air
pressure is restored.
English
Air expands in the midday heat.
Air pressure release valve kicks
in and releases excess air.
Page 11
351
PO
9