Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Zehnder Rittling FSP 330
Summary of Contents for Zehnder Rittling FSP 330
- Page 1 FSP 330 OPERATING MANUAL For safe and proper application, please carefully read the operating manual and further product-accompanying documents. The operating manual has to be handed over to the fi nal user and kept until product disposal.
- Page 2 That is why no claims can be made due to information and fi gures provided in this operating manual. If the fl at suction pump FSP 330 is used with electronic level control, two operating manuals will have to observed at the same time: •...
-
Page 3: Table Of Contents
Flat suction pump FSP 330 English Table of Contents General aspects ....................26 1.1 Introduction..................... 26 1.2 Warranty ......................26 Safety ........................27 2.1 Symbols in this operating manual ..............27 2.2 Intended use....................28 2.3 Selection and qualifi cation of persons ............29 2.4 Personal protective equipment ............... -
Page 4: General Aspects
In case of any queries about the fl at suction pump FSP 330 and this operating manual, please get in touch with: Zehnder Pumpen GmbH Zwönitzer Straße 19... -
Page 5: Safety
Flat suction pump FSP 330 English 2 Safety These operating manual contain basic instructions which have to be observed during set-up, operation and maintenance. For this reason, these operating manual must by all means be read before installation and commissioning by the installation technician as well as by the competent specialist staff... -
Page 6: Intended Use
• cellars, washhouses, pools, shafts • wherever water must be pumped off “completely” Pumps of model range Flat suction pump FSP 330 can be used for commercial or non- commercial applications. For conveying slightly contaminated water with suspended solids (no rocks) up to 1 mm grain size from private households, industry and agriculture. -
Page 7: Selection And Qualification Of Persons
Flat suction pump FSP 330 English Also an automatically working device, such as a submersible pump, must not be operated unattended for a longer period. If you leave the device for a longer period, then please disconnect the power supply of the device. -
Page 8: Personal Protective Equipment
Flat suction pump FSP 330 English 2.4 Personal protective equipment For various activities on the pump, personal protective equipment is required, if necessary. Personal protective equipment has to be provided to the personnel and their use has to be checked by supervisory staff . -
Page 9: Basic Hazard Potential
Flat suction pump FSP 330 English 2.5 Basic hazard potential If hot or cold machine parts could lead to hazards, these parts have to be protected against touch by the user. Touch protection for moving parts (such as coupling) must not be removed from plants in operation. -
Page 10: Hazards Caused By Non-Observation Of Safety Instructions
Flat suction pump FSP 330 English 2.7 Hazards caused by non-observation of safety instructions The non-observation of the safety instructions may endanger persons as well as the environment, and may have consequences for the environment and machine. The non- observation of the safety instructions will result in the loss of all claims for damages. -
Page 11: Transport And Storage
Flat suction pump FSP 330 English 3 Transport and storage 3.1 Transport During transport, it has to be made sure that the pump cannot be knocked into and is not dropped. 3.2 Temporary storage / conservation For this purpose, the plant has to be warehoused horizontally in a dry, dark or sun- protected as well as frost-proof area. -
Page 12: Installation
Flat suction pump FSP 330 English 5 Installation 5.1 Preparations Check whether according to the packaging the plant is suitable for the power system (230 V / 50 Hz). Make sure that all safety rules are observed. Check whether the conveyed media corresponds to the media mentioned in chapter 2.2. - Page 13 Flat suction pump FSP 330 English Safety instructions The pump must not be put into operation with a damaged cable Using the pump at swimming pools and garden ponds is permis- sible only if the systems have been set up in accordance with DIN VDE 0100/Part 702.
-
Page 14: Commissioning And Operation
Flat suction pump FSP 330 English 6 Commissioning and operation Before commissioning, all connections have to be checked again for correct installation. It has to be made sure in particular that voltage and frequency of the mains and fl at suction pump (see type plate) match. -
Page 15: Handing Over The Plant To The User
Flat suction pump FSP 330 English 6.1 Handing over the plant to the user When handing over the plant to the user: • Explain the functionality of the pump. • Hand over the pump when it is fully functional. • Deliver the handover report with essential data of commissioning (e.g. changes to the factory settings). - Page 16 Flat suction pump FSP 330 English 2. Remove dirt particles from the impeller and lower side and check for grinding marks of the impeller at the bottom interior. 3. After cleaning, reassemble the pump. To do this, clean the upper edge of the pump bottom and caulk it using silicone.
-
Page 17: Detecting And Removing Malfunctions
Flat suction pump FSP 330 English 8 Detecting and removing malfunctions Malfunction Cause Troubleshooting Motor does not rotate • Supply voltage missing • Check if the plug is in the outlet • defective power cable • Replacement (customer service) • Impeller blocked •... -
Page 18: Technical Data
Flat suction pump FSP 330 English 9 Technical data Frequency 50 Hz max. medium temperature 40° C max. operating temperature 40° C Maximum grain size 1 mm Protection class IP 68 Pressure connection 1“, internal thread Cable H05 RN-F, 10 m... -
Page 19: Characteristic Curve
Flat suction pump FSP 330 English Characteristic curve 9.1 Type plate A type plate containing all essential technical data is attached to the pump. -
Page 20: Lists Of Spare Parts
Flat suction pump FSP 330 English 10. List of spare parts... - Page 21 Flat suction pump FSP 330 English Zehnder factory Item FSP 330 Number number Motor unit, complete with rotor and impeller 12669 Seal ring D = 6 15739 Sealing plug 15755 O-Ring 88x4 11852 Radial shaft seal 8x22x7 16804 End-face mechanical seal...
-
Page 22: Environmental Notes
Flat suction pump FSP 330 English 11 Environmental notes The cardboard packaging is recyclable and to be supplied to waste paper recycling. Please make the polystyrene cushions available for removal by the dual system (yellow bag). Waste electric and electronic equipment often contain materials which can be reused. But they also include harmful substances which were necessary for the function and safety of the device.
Need help?
Do you have a question about the FSP 330 and is the answer not in the manual?
Questions and answers